22.Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the tool’s operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly main- tained tools.
23.Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one tool may become hazardous when used on another tool.
SERVICE
24.Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel could result in a risk of injury.
25.When servicing a tool, use only identical replacement parts. Follow instructions in the “Inspection, Maintenance, And Cleaning” section of this manual. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury.
SPECIFIC SAFETY RULES
1.Maintain a safe working environment. Keep the work area well lit. Make sure there is adequate surrounding workspace. Always keep the work area free of obstructions, grease, oil, trash, and other debris. Do not use the Router Table in areas near flammable chemicals, dusts, and vapors. Do not use this product in a damp or wet location.
2.Maintain labels and nameplates on the Router. These carry important information. If unreadable or missing, contact Harbor Freight Tools for a replace- ment.
3.Do not force the equipment. This Router will do the work better and safer at the speed and capacity for which it was designed.
4.Keep all guards in place and in working order.
5.Remove all adjusting wrenches from the Router before turning it on.
6.Do not abuse the Power Cord. Do not use the Power Cord to pull its Plug from an electrical outlet. Keep the Power Cord away from heat, oil, sharp edges, and moving parts. Route the Power Cord safely. Protect the Power Cord from being damaged by other equipment in the work area. Do not route the Power Cord where it can be walked on or tripped over. Replace a damaged Power Cord immediately.
SKU 91130 | For technical questions, please call | Page 5 |