2.Attach the second Feather Board (21B) horizontally to the Main Table (20B). To do so, insert two Square Head Screws (11B) upward through the Feather Board. Then slide the head of both Screws into the keyhole slot located in the channel used for the Miter Gauge (27C). Secure the Feather Board to the Main Table, using two Large Washers (13B) and two Large Lock Knobs (14B).
(See Figure S.)
LARGE LOCK KNOB |
|
| FEATHER | ||
(14B) |
|
| BOARD | ||
LARGE WASHER |
|
| (21B) | ||
|
|
| MITER GAUGE CHANNEL | ||
(13B) |
|
|
| ||
|
|
| |||
|
|
|
|
| |
SQUARE HEAD SCREW (11B) |
|
|
|
|
|
|
|
|
|
| |
FEATHER BOARD (21B) |
|
|
|
|
|
|
|
|
|
| |
MAIN TABLE (20B)
FIGURE S
3.NOTE: The Feather Boards (14C, 21B) are designed to hold the workpiece in place and prevent kickback. To adjust the Feather Boards, simply loosen the Lock Knobs (8C, 14B) and move the Feather Boards into the workpiece. Then, retighten the Lock Knobs. Make sure the “feathers” of the Feather Boards allow easy feed of the workpiece and help prevent kickback. (See Figures R and S.)
To Attach The Miter Gauge:
1.The Miter Gauge (27C) slides horizontally along the Main Table (20B) and is designed for edging and miter cuts in the workpiece. (See Figure T, next page.)
2.To attach the Miter Gauge (27C), simply slide its bar into the Miter Gauge Chan- nel on the Main Table (20B). (See Figure T.)
3.To adjust the Miter Gauge (27C) to the desired angle, loosen the Fence Lock Knob (8C) and rotate the Miter Gauge to the desired angle from 0 degrees to 45 degrees. Then, retighten the Fence Lock Knob. (See Figure T.)
SKU 91130 | For technical questions, please call | Page 22 |