Harbor Freight Tools 91130 See Assembly Diagram C and Figure M, To Install And Remove Collets

Page 18

rear of the Upper Fence (16C), using the remaining two pre-fitted Nuts (11C) in the channel of the Upper Fence and two Screws (9C).

(See Assembly Diagram C and Figure M.)

PROTECTOR

(23C)

UPPER FENCE (16C)

DUST PORT ASSY.

(26C)

FENCE LOCK KNOB

(8C)

FIGURE M

To Install And Remove Collets:

1.WARNING! Always make sure the Power Switch (9B) is in its “OFF” position and the Power Cord/Plug (1B) is unplugged from its electrical outlet before making any adjustments to the Router Table.

2.The Router is equipped with a 1/4” Collet (18D) and a 1/2” Collet (24D).

3.The Collet (18D, 24D) may need to be changed to allow use of larger or smaller diameter router bits (not included).

4.NOTE: When changing Collets (18D, 24D) or when changing router bits, the height of the Motor Assembly should be raised to the maximum height to gain full access to the Collet Nut (19D).

5.Unlock the Height Adjustment Lock (23D) by rotating it in a counterclockwise direction, using the end of the Wrench (21D) provided.

(See Figure N, next page.)

6.Remove the Collet Assembly Cover (15D) by removing the two inner Screws (1D) on the Cover and lifting the Cover away from the Height Adjusting Ring (14D). If necessary, clean off any saw dust and debris which may have built up from previous cutting operations. (See Figure N.)

SKU 91130

For technical questions, please call 1-800-444-3353.

Page 18

Image 18
Contents For technical questions or replacement parts, please call Router with Full Size TableUnpacking Product SpecificationsGeneral Safety Rules Save this ManualElectrical Safety Personal SafetyTool USE and Care Specific Safety Rules ServiceSKU For technical questions, please call Page Page Grounding Grounded Tools Tools with Three Prong PlugsSee Figure C, next Extension CordsDouble Insulated Tools Tools with TWO Prong Plugs See Figure CSymbology Figure CProduct Features Figure EAssembly Instructions Assembly Diagrams on pages 28, 29, 30, 31,To Assemble The Base To Assemble The Mid-Section See Figure GFront View See Figure I, next To Attach The Mid-Section To The BodySee Figure H To Attach The Main TableSee Figure J Figure JTo Attach The Motor Assembly To Attach The FenceSee Assembly Diagram C and Figure L See Assembly Diagram CTo Attach The Dust Port Assembly And Protector See Assembly Diagram C and Figure M To Install And Remove ColletsSee Figure N, next Figure N To Adjust The Depth Of Cut See Figures K and PTo Attach And Adjust The Feather Boards Figure RSee Figure S To Attach The Miter GaugeTo Adjust The Upper Fence To Adjust The Speed RPMSee Figure U To Turn On The Router Table To Operate The Router TableINSPECTION, MAINTENANCE, and Cleaning Please Read the Following CarefullyDo not use damaged equipment Parts List a Parts List BParts List C Parts List D Parts List EAssembly Diagram a Assembly Diagram B Assembly Diagram C Assembly Diagram D Assembly Diagram E