DeWalt DWE315K Attaching the Cut Guide Fig, INSTALLING/REMOVING Sanding Sheets FIG, Depth Guide

English

INSTALLING/REMOVING SANDING SHEETS (FIG. 5)

A diamond shaped platen uses a hook and loop adhesion system to attach the sanding sheets. The platen allows you to use it on large flat surfaces and tight spots or corners.

1. Attach the sanding platen (I) as

FIG. 5

J

CAUTION: To avoid injury, do not use any accessory for an application where the adaptor may fail to hold the accessory.

CAUTION: Read and follow all manufacturers' safety warnings for any accessories used with this tool.

CAUTION: To avoid injury, ensure adaptor and accessory are securely tightened.

Attaching the Cut Guide (Fig. 7–11)

described	under	Installing/
Removing Accessories.
2. Align the edges on the sanding
sheet, with the edge of the sanding
platen and press the sanding sheet
(J) onto the platen.

I

The depth/cut guide allows you to precisely cut material at a specified depth and more accurately track a marked cut line.

1. Attach the cut guide block (F) by

inserting the tabs (M) on the guide into

the accessory side mount (E) on the

FIG. 7

E

3.Firmly press the base with the sanding sheet attached against a flat surface and briefly switch the tool on. This provides for good adhesion between the platen and the sanding sheet and also helps to prevent premature wear.

4.When the tip of the sanding sheet becomes worn, detach the sheet from the platen, rotate and reapply.

ATTACHING ACCESSORIES USING THE UNIVERSAL ADAPTER (FIG. 6)

Non-DEWALT accessories can be	FIG. 6
attached using the universal adaptor.

main body of the tool.

2. Secure the block to the main body with

the supplied screw (O) and tighten with

the supplied hex wrench (P).

DEPTH GUIDE

This feature allows you to precisely cut material at a specified depth.

1.Insert the guide arm (G) as shown in Figure 8 into the front slot on the guide block (F).

M

F

O

P

1. Place the washer (K) on the tool.

2. Place accessory on to washer.

3. Tighten and secure adaptor nut (L) using a hex wrench.

L K

2.Adjust the length of the guide by pulling out or pushing inward to achieve the desired cut depth as shown in Figure 9.

3.Secure the guide in place by turning the depth/cut adjustment knob clockwise. To release the guide, turn the depth/cut adjustment knob counterclockwise.

6