DeWalt DWE315K instruction manual For Future USE, Motor

English

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.

•Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.

WARNING: Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body.

WARNING: Always wear proper personal hearing protection that conforms to ANSI S12.6 (S3.19) during use. Under some conditions and duration of use, noise from this product may

BPM	beats per minute	n	rated
OPM	oscillations per minute		speed
RPM	revolutions per		earthing
	minute		terminal
sfpm	surface feet		.....................safety alert
.....................	per minute		symbol
SPM	strokes per minute

SAVE THESE INSTRUCTIONS

FOR FUTURE USE

Motor

Be sure your power supply agrees with the nameplate marking. Voltage decrease of more than 10% will cause loss of power and overheating. DEWALT tools are factory tested; if this tool does not operate, check power supply.

contribute to hearing loss.

•The label on your tool may include the following symbols. The symbols and their definitions are as follows:

	V			volts	A		amperes
	Hz			hertz	W		watts
	min			minutes		or AC	alternating
			or DC	direct current			current
				Class I Construction		or AC/DC	alternating
		.................
	.....................			(grounded)	........................		or direct
		.................		Class II Construction	no		current
				(double insulated)		....................	no load
…/min				per minute			speed

4

FIG. 1

B

E A

C

F

G

D