Epson 31-396 instruction manual Cover

Page 10

COVER

1.Align the hinges (A) Fig. 14, on the cover, with the hinges (B) on the belt guard.

2.Insert hinge pins (C) and (D) Fig. 15, through the hinges on the cover and belt guard.

3.Tap the hinge pins in with hammer and rod (supplied).

4.Latch lever (E) Fig. 16 to the cover.

A

B

B

Fig. 14

CD

Fig. 15

E

Fig. 16

10

Image 10

Contents Oscillating Edge Sander Safety Guidelines Definitions SAVE! Important Safety Instructions SaveStay ALERT, Watch What YOU are Doing Additional Safety Rules For Abrasive Finishing MachinesUSE a Dust Collection System Power Connections Unpacking and Cleaning Extension CordsKJ H Oscillating Edge Sander Parts 911 810 2328 2429Assembly BeltBack Stop CD BCover Dust Port Sanding SpindlePage Page Fence Disconnect Machine from Power Source Operating Controls and AdjustmentsLocking Switch OFF Position Starting and Stoping Oscillating Edge SanderTable Distance to Belt Angle of Belt Sander Belt TrackingSpindle Sander Table Miter GageOperations Shows sanding with the miter gageStorage Shows sanding at 45 degrees to the table with the miter gageMaintenance LubricationRemoving the Drum Accessories PARTS, Service or Warranty AssistanceCanadian PORTER-CABLE Delta Service Centers