MAINTENANCE
LUBRICATION
After the machine has been operated for approximately 500 hours, check oil level.
DISCONNECT MACHINE FROM POWER
SOURCE.
1.Make sure that the belt sander is in the horizontal position as shown in Fig. 55.
2.Remove the two screws (A) Fig. 56, on top of the gear box cover (G) Fig. 55.
3.Remove the two screws, located right below screws
(A) Fig. 56, on the bottom of the gear box cover. Remove the gear box cover.
4.Remove the screw (D) Fig. 57, on top of the gear box.
5.Fill the gear box with machine oil and replace screw
(D) Fig. 57.
6.Replace the gear box cover and screws that were removed in STEPS 2, 3, AND 4.
G
Fig. 55
A
Fig. 56
D
Fig. 57
21