Epson 31-396 instruction manual Dust Port, Sanding Spindle

DUST PORT

1.Align the four holes on the dust port (A) Fig. 17, with the four tapped holes (B) on the side of the belt sander.

2.Place a 17/64" flat washer on a 1/4-20x3/8" round head screw, insert the screw through the hole in the dust port, and thread the screw into the tapped hole on the side of the belt sander. Repeat this process for the three remaining holes in the dust port and belt sander. Tighten all four screws securely.

3.NOTE: If this machine is to be used with a dust collection system, slide the 4" O.D. hose connector over the dust port as shown in Fig. 18.

AB

B

Fig. 17

Fig. 18

SANDING SPINDLE

1.Release latch lever (A) Fig. 19 on the belt guard.

A

Fig. 19

11