Epson 31-396 instruction manual Back Stop, Cd B

6.Slowly release the belt tension lever handle (G) Fig. 10, by grasping the lever handle (G) and pushing it in until it stops.

7.Raise the belt guards (E) and (F) Fig. 11.

8.Latch levers (A) and (B) Fig. 11 to belt guards (E) and

(F).

9.Replace knobs (C) and (D) Fig. 11, that were removed in STEP 1.

BACK STOP

NOTE: THE BOTTOM OF THE BACK STOP (C) FIG. 13 SHOULD BE SET SLIGHTLY ABOVE THE BELT SANDER TABLE.

1.Place a 5/16" flat washer on each 5/16-18 x 1" hex head screw. Thread screws into table two complete turns.

2.Place back stop (A) Fig. 12, on screws (B) between table and washers and tighten securely.

G

Fig. 10

CD B

F

A E

Fig. 11

A

B

Fig. 12

C

Fig. 13

9