ANGLE OF BELT SANDER
DISCONNECT MACHINE FROM POWER SOURCE.
1.The belt sander can be tilted from 0 degrees to the table up to 90 degrees to the table.
2.Move the table to the front of the machine. Grasp the tilting handle (C) Fig. 39.
GRASP THE TILTING HANDLE FIRMLY WHEN REPOSITIONING THE BELT SANDER.
3.Position the detent pin (A), as shown in Fig. 41.
4.Loosen ratchet handle (B) Fig. 40.
5.Push down on the handle (C) Fig. 39 until the pointer
(D) Fig. 41 lines up with the desired angle on the scale
(E).
6. Tighten ratchet handle (B) Fig. 41.
NOTE: THE DETENT LOCK PIN (A) FIG. 40 ALLOWS FOR QUICK ADJUSTMENTS TO 0 DEGREES, 45 DEGREES, AND 90 DEGREES TO THE TABLE.
C
Fig. 39
A
B
Fig. 40
B
E
D
A
Fig. 41
BELT TRACKING
DISCONNECT MACHINE FROM POWER SOURCE.
1.Loosen nut (A) Fig. 42.
2.Turn nut (B) Fig. 42, clockwise or counter clockwise to adjust belt tracking.
3.When belt is tracking properly, retighten nut (A) Fig. 42.
A
Fig. 42
B
17