12. Assemble appropriate table insert onto the table |
|
using the three screws that were removed in STEP 10. | O |
|
O
O
Fig. 28
FENCE
If sanding with the belt in the horizontal position, the use of the fence is recommended.
1.Place the fence (A) on the table as shown in Fig. 29.
2.Align the slots (B) Fig. 29, in the fence with the tapped holes (C) in the table.
CC 
BB
A
Fig. 29
3.Place a 5/16" flat washer (D) Fig. 30, on the fence knob (E).
4.Insert knob through slot (B) Fig. 30, and thread knob into tapped hole in table and tighten securely. Repeat this process for the remaining fence knob.
EE
B 
DD
B
Fig. 30
14