Alpha Tool.Com.HK Limited VSP-230 Variable Speed WET Polisher Operation, Main Connection

Page 12

VSP-230 VARIABLE SPEED WET POLISHER OPERATION

CAUTION!

Always be sure that the tool is switched off and unplugged before adjusting or checking function on tool.

MAIN CONNECTION

Connect only to single-phase AC current supply and only to the main voltage speciﬁed on the rating plate.

SWITCHING ON AND OFF

CAUTION!

Before plugging in the tool, always check the working voltage be sure that the voltage speciﬁed is on the name plate. Before plugging in the tool, always check to see that the slide switch actuates properly and returns to the “OFF” position when the rear of the slide switch is depressed.

Switching on:

Switch can be locked in “ ON” position for ease of operator comfort during extended use. Apply caution when locking tool in “ON” position and maintain ﬁrm grasp on tool. Push power switch to the forward position until it locks into position as shown in Figure 3.

Switching off:

Push down on power switch to release to the rear position as shown in Figure 4.

ON POSITION

Figure-3

OFF POSITION

Figure-4

12

Image 12

Contents Alpha Variable Speed Wet Polisher Table of Contents Specifications VSP-230 OverviewAccessories ComponentsAbout the Symbols IntroductionGeneral Safety Rules Electrical SafetyPersonal Safety Work AreaService Tool USE and CareSpecific Safety Rules USE Proper Extension Cords Grounding InstructionsAdditional Precautions for Using the VSP-230 Check the working voltageBe careful of your surroundings when working in high places Laws and Regulations of Noise LevelsSwitching on and OFF VSP-230 Variable Speed WET Polisher OperationMain Connection Ground Fault Circuit Interrupter Gfci Gfci InformationVariable Speed Adjustment Testing IN-LINE Gfci Unit Before Each Use Of The PolisherSpeed POT Feedback Sensor Water Control ValveSide Handle Installation Customizing the Splash Guard Recommended HeightsSplash Guard Installation Profiler and Other Approved Spindle Attachments WATER-FEED AttachmentMaintenance DailyPeriodic Carbon Brush Replacement Bearings and GearsRear Cover Removal Page Spade Connector New Carbon Brush Clean Dirty Alpha VSP-230 Schematic Alpha VSP-230 Parts List Drawing no Description QuantityRing Services and Warranty Information Loaner Program Need More InformationAlpha Tool Repair Service WarrantyEC Declaration of Conformity Frequently Asked Questions Appendix aHelpful Hints Product Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax