Alpha Tool.Com.HK Limited VSP-230 instruction manual Spade Connector

Page 24

Carbon Brush

Spring

Carbon Brush

Holder

Carbon Brush

Wire

Figure-32

9.Lift the spring from the carbon brush and place on the side of the brush holder.

Figure-33

10.Remove the carbon brush wire spade connector from the terminal post and then remove the carbon brush.

Spade Connector

Figure-34

Figure-35

24

Image 24

Contents Alpha Variable Speed Wet Polisher Table of Contents Specifications VSP-230 OverviewAccessories ComponentsAbout the Symbols IntroductionGeneral Safety Rules Electrical SafetyPersonal Safety Work AreaService Tool USE and CareSpecific Safety Rules USE Proper Extension Cords Grounding InstructionsAdditional Precautions for Using the VSP-230 Check the working voltageBe careful of your surroundings when working in high places Laws and Regulations of Noise LevelsSwitching on and OFF VSP-230 Variable Speed WET Polisher OperationMain Connection Ground Fault Circuit Interrupter Gfci Gfci InformationVariable Speed Adjustment Testing IN-LINE Gfci Unit Before Each Use Of The PolisherSpeed POT Feedback Sensor Water Control ValveSide Handle Installation Customizing the Splash Guard Recommended HeightsSplash Guard Installation Profiler and Other Approved Spindle Attachments WATER-FEED AttachmentMaintenance DailyPeriodic Carbon Brush Replacement Bearings and GearsRear Cover Removal Page Spade Connector New Carbon Brush Clean Dirty Alpha VSP-230 Schematic Alpha VSP-230 Parts List Drawing no Description QuantityRing Services and Warranty Information Loaner Program Need More InformationAlpha Tool Repair Service WarrantyEC Declaration of Conformity Frequently Asked Questions Appendix aHelpful Hints Product Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax