Alpha Tool.Com.HK Limited VSP-230 instruction manual Splash Guard Installation

Page 18

SPLASH GUARD INSTALLATION

CAUTION!

The splash guard should be used to prevent the water and dust from going inside the tool. Failure to do so can shorten the life of your tool and void the limited warranty.

1.Install the rubber splash guard into the tool so that the lip on the splash guard ﬁts into the groove on the tool and the cutout is around the water ﬁtting.

2.Open the band clamp completely and wrap around the splash guard under the water ﬁtting.

3.Tighten the clamp until snug.

Groove

Figure-18

Figure-19

Figure-20

18

Image 18

Contents Alpha Variable Speed Wet Polisher Table of Contents Specifications VSP-230 OverviewAccessories ComponentsAbout the Symbols IntroductionPersonal Safety General Safety RulesElectrical Safety Work AreaService Tool USE and CareSpecific Safety Rules USE Proper Extension Cords Grounding InstructionsAdditional Precautions for Using the VSP-230 Check the working voltageBe careful of your surroundings when working in high places Laws and Regulations of Noise LevelsSwitching on and OFF VSP-230 Variable Speed WET Polisher OperationMain Connection Ground Fault Circuit Interrupter Gfci Gfci InformationVariable Speed Adjustment Testing IN-LINE Gfci Unit Before Each Use Of The PolisherSpeed POT Feedback Sensor Water Control ValveSide Handle Installation Customizing the Splash Guard Recommended HeightsSplash Guard Installation Profiler and Other Approved Spindle Attachments WATER-FEED AttachmentMaintenance DailyPeriodic Carbon Brush Replacement Bearings and GearsRear Cover Removal Page Spade Connector New Carbon Brush Clean Dirty Alpha VSP-230 Schematic Alpha VSP-230 Parts List Drawing no Description QuantityRing Services and Warranty Information Loaner Program Need More InformationAlpha Tool Repair Service WarrantyEC Declaration of Conformity Frequently Asked Questions Appendix aHelpful Hints Product Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax