Alpha Tool.Com.HK Limited VSP-230 Speed POT Feedback Sensor, Water Control Valve

Page 15

SPEED POT FEEDBACK SENSOR

This polisher is equipped with a Closed Loop Feedback sensor that is attached to the speed pot. When a load is applied to the tool, the sensor will re-adjust the RPM to maintain a constant speed.

WATER CONTROL VALVE

CAUTION!

Adjust the water ﬂow to wet the stone and remove waste, excessive spray and mist will get inside the tool and cause premature failure of the tool and/or cause the GFCI to trip.

This polisher is equipped with a center water-feed system. Water ﬂow to the spindle shower bolt can be controlled by throttling the valve stem as seen in Figure 8, Figure 9 and Figure 10.

Water Valve in closed position

Figure-8

Water Valve in half open position

Figure-9

Water Valve in full open position

Figure-10

15

Image 15

Contents Alpha Variable Speed Wet Polisher Table of Contents VSP-230 Overview SpecificationsComponents AccessoriesIntroduction About the SymbolsWork Area General Safety RulesElectrical Safety Personal SafetyTool USE and Care ServiceSpecific Safety Rules Grounding Instructions USE Proper Extension CordsCheck the working voltage Additional Precautions for Using the VSP-230Laws and Regulations of Noise Levels Be careful of your surroundings when working in high placesSwitching on and OFF VSP-230 Variable Speed WET Polisher OperationMain Connection Gfci Information Ground Fault Circuit Interrupter GfciTesting IN-LINE Gfci Unit Before Each Use Of The Polisher Variable Speed AdjustmentWater Control Valve Speed POT Feedback SensorSide Handle Installation Recommended Heights Customizing the Splash GuardSplash Guard Installation WATER-FEED Attachment Profiler and Other Approved Spindle AttachmentsMaintenance DailyPeriodic Bearings and Gears Carbon Brush ReplacementRear Cover Removal Page Spade Connector New Carbon Brush Clean Dirty Alpha VSP-230 Schematic Drawing no Description Quantity Alpha VSP-230 Parts ListRing Need More Information Services and Warranty Information Loaner ProgramWarranty Alpha Tool Repair ServiceEC Declaration of Conformity Appendix a Frequently Asked QuestionsHelpful Hints Product Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax