Alpha Tool.Com.HK Limited VSP-230 Profiler and Other Approved Spindle Attachments

Page 19

PROFILER AND OTHER APPROVED SPINDLE ATTACHMENTS

CAUTION!

Do not leave threaded accessories on the spindle of the tool for extended periods of time, as this may result in making it difﬁcult to remove these accessories.

The VSP-230 polisher has a M14-2 center water-feed spindle thread.

To attach a proﬁler wheel or other ap- proved spindle attachments, follow the steps below:

1.Screw the attachment onto the spindle by hand.

Figure-21

2.Tighten with supplied wrench.

NOTE : If attachment does not thread on freely, check threads on both sur- faces for damage or dirt. Clean, repair or replace as needed to ensure a safe and tight connec- tion to the polisher.

Figure-22

WATER-FEED ATTACHMENT

Attach the polisher water-line ﬁtting to any garden hose connection.

OPERATION

WARNING!

To reduce the risk of electric shock, check the tool’s water supply system to ensure there is no damage to the seals or hoses. A damaged water supply system may result in abnormal water ﬂow to the tool which could be dangerous.

19

Image 19

Contents Alpha Variable Speed Wet Polisher Table of Contents VSP-230 Overview SpecificationsComponents AccessoriesIntroduction About the SymbolsWork Area General Safety RulesElectrical Safety Personal SafetyTool USE and Care ServiceSpecific Safety Rules Grounding Instructions USE Proper Extension CordsCheck the working voltage Additional Precautions for Using the VSP-230Laws and Regulations of Noise Levels Be careful of your surroundings when working in high placesVSP-230 Variable Speed WET Polisher Operation Switching on and OFFMain Connection Gfci Information Ground Fault Circuit Interrupter GfciTesting IN-LINE Gfci Unit Before Each Use Of The Polisher Variable Speed AdjustmentWater Control Valve Speed POT Feedback SensorSide Handle Installation Recommended Heights Customizing the Splash GuardSplash Guard Installation WATER-FEED Attachment Profiler and Other Approved Spindle AttachmentsDaily MaintenancePeriodic Bearings and Gears Carbon Brush ReplacementRear Cover Removal Page Spade Connector New Carbon Brush Clean Dirty Alpha VSP-230 Schematic Drawing no Description Quantity Alpha VSP-230 Parts ListRing Need More Information Services and Warranty Information Loaner ProgramWarranty Alpha Tool Repair ServiceEC Declaration of Conformity Appendix a Frequently Asked QuestionsHelpful Hints Product Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax