Alpha Tool.Com.HK Limited VSP-230 instruction manual Variable Speed Adjustment

Page 14

TESTING IN-LINE GFCI UNIT (Before Each Use Of The Polisher)

1.Connect polisher to a single phase AC power supply.

2.Verify that the indicator lens shows red (indicating output voltage).

3.Press the test button to verify that the red in the indicator lens disappears.

4.Press the reset button to verify the red indicator is visible.

5.The GFCI is now ready for use.

WARNING!

DO NOT USE IF ABOVE TEST FAILS!

RESET BUTTON

Indicator viewing lens.

RED lens shows power to polisher.

CLEAR lens shows no power to polisher.

TEST BUTTON

Figure-6

Figure-5

VARIABLE SPEED ADJUSTMENT

This polisher is equipped with a Variable Speed control that will allow the spindle speed to be adjusted from 500 RPM to 2800 RPM. Speed adjustment is controlled by rotation of the wheel as shown in the Figure 4.

NOTE- Wheel numbers are for reference point of motor speed (#1 is 500 RPM and #6 is 2800 RPM).

Adjust the RPM of the tool to match the recommended RPM of the product being used.

DECREASE SPEED

INCREASE SPEED

Figure-7

14

Image 14

Contents Alpha Variable Speed Wet Polisher Table of Contents Specifications VSP-230 OverviewAccessories ComponentsAbout the Symbols IntroductionPersonal Safety General Safety RulesElectrical Safety Work AreaService Tool USE and CareSpecific Safety Rules USE Proper Extension Cords Grounding InstructionsAdditional Precautions for Using the VSP-230 Check the working voltageBe careful of your surroundings when working in high places Laws and Regulations of Noise LevelsMain Connection Switching on and OFFVSP-230 Variable Speed WET Polisher Operation Ground Fault Circuit Interrupter Gfci Gfci InformationVariable Speed Adjustment Testing IN-LINE Gfci Unit Before Each Use Of The PolisherSpeed POT Feedback Sensor Water Control ValveSide Handle Installation Customizing the Splash Guard Recommended HeightsSplash Guard Installation Profiler and Other Approved Spindle Attachments WATER-FEED AttachmentPeriodic MaintenanceDaily Carbon Brush Replacement Bearings and GearsRear Cover Removal Page Spade Connector New Carbon Brush Clean Dirty Alpha VSP-230 Schematic Alpha VSP-230 Parts List Drawing no Description QuantityRing Services and Warranty Information Loaner Program Need More InformationAlpha Tool Repair Service WarrantyEC Declaration of Conformity Frequently Asked Questions Appendix aHelpful Hints Product Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax