Alpha Tool.Com.HK Limited VSP-230 instruction manual Rear Cover Removal

Page 22

REAR COVER REMOVAL

1.Gently pull water tube away from holder.

Figure-24

2.Release the tube from the holder.

Figure-25

3. Unwrap 3 inches of the coiled harness.

Figure-26

4.Remove the 2 screws from the valve

bracket.

Figure-27

22

Image 22

Contents Alpha Variable Speed Wet Polisher Table of Contents Specifications VSP-230 OverviewAccessories ComponentsAbout the Symbols IntroductionPersonal Safety General Safety RulesElectrical Safety Work AreaService Tool USE and CareSpecific Safety Rules USE Proper Extension Cords Grounding InstructionsAdditional Precautions for Using the VSP-230 Check the working voltageBe careful of your surroundings when working in high places Laws and Regulations of Noise LevelsVSP-230 Variable Speed WET Polisher Operation Switching on and OFFMain Connection Ground Fault Circuit Interrupter Gfci Gfci InformationVariable Speed Adjustment Testing IN-LINE Gfci Unit Before Each Use Of The PolisherSpeed POT Feedback Sensor Water Control ValveSide Handle Installation Customizing the Splash Guard Recommended HeightsSplash Guard Installation Profiler and Other Approved Spindle Attachments WATER-FEED AttachmentDaily MaintenancePeriodic Carbon Brush Replacement Bearings and GearsRear Cover Removal Page Spade Connector New Carbon Brush Clean Dirty Alpha VSP-230 Schematic Alpha VSP-230 Parts List Drawing no Description QuantityRing Services and Warranty Information Loaner Program Need More InformationAlpha Tool Repair Service WarrantyEC Declaration of Conformity Frequently Asked Questions Appendix aHelpful Hints Product Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax