Alpha Tool.Com.HK Limited VSP-230 Ground Fault Circuit Interrupter Gfci, Gfci Information

Page 13

GROUND FAULT CIRCUIT INTERRUPTER (GFCI)

A Ground Fault Circuit Interrupter is built in-line with the power supply cord to protect the operator from electric shock.

1.GFCI Information.

–Alpha® Wet Polisher is provided with an in-line GFCI as a standard accessory for your safety, and to prevent possible electric shocks. It is strongly advised to test the GFCI on a regular basis.

DANGER!

Never attach a damaged extension cord to the polisher.

NOTE: Use the appropriate extension cord, see table on page 9.

CAUTION!

When the GFCI trips, this could be the result of water entering the polisher housing.

1.Turn OFF the power switch, disconnect polisher from power supply and blow dry air inside the motor cover through the air vents.

2.Re-connect power supply and press the GFCI reset button. The polisher is ready to start working once the reset button is pressed down.

DANGER!

Always check that the GFCI unit is working correctly (reset, test, and reset) before using this tool. Do not use the tool if the GFCI is not working correctly. Do not bypass the GFCI if this condition occurs, a real shock hazard may exist.

WARNING!

If the GFCI fails to trip when the test button is pressed, or fails to reset, the device is defec- tive and should replaced.

CAUTION!

1.The GFCI is a safety device, do not use as an on/off switch.

2.The GFCI on the tool will not protect you if you cut into another current carrying conductor.

3.Do not use where water may enter GFCI case.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Alpha Variable Speed Wet Polisher Table of Contents VSP-230 Overview SpecificationsComponents AccessoriesIntroduction About the SymbolsElectrical Safety General Safety RulesPersonal Safety Work AreaTool USE and Care ServiceSpecific Safety Rules Grounding Instructions USE Proper Extension CordsCheck the working voltage Additional Precautions for Using the VSP-230Laws and Regulations of Noise Levels Be careful of your surroundings when working in high placesVSP-230 Variable Speed WET Polisher Operation Switching on and OFFMain Connection Gfci Information Ground Fault Circuit Interrupter GfciTesting IN-LINE Gfci Unit Before Each Use Of The Polisher Variable Speed AdjustmentWater Control Valve Speed POT Feedback SensorSide Handle Installation Recommended Heights Customizing the Splash GuardSplash Guard Installation WATER-FEED Attachment Profiler and Other Approved Spindle AttachmentsDaily MaintenancePeriodic Bearings and Gears Carbon Brush ReplacementRear Cover Removal Page Spade Connector New Carbon Brush Clean Dirty Alpha VSP-230 Schematic Drawing no Description Quantity Alpha VSP-230 Parts ListRing Need More Information Services and Warranty Information Loaner ProgramWarranty Alpha Tool Repair ServiceEC Declaration of Conformity Appendix a Frequently Asked QuestionsHelpful Hints Product Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax
Top Page Image Contents