Alpha Tool.Com.HK Limited VSP-230 instruction manual

Page 23

5.Pull the valve assembly away from mount.

6.Remove the rear case screw.

7.Hold polisher with one hand and pull the rear case straight back with the other hand.

NOTE: Do not twist case in a side to side motion when pulling back.

8.Pull back the rear case until the carbon brush assembly is exposed.

NOTE: Do not pull rear case further back from this point.

Figure-28

Figure-29

Figure-30

Figure-31

23

Image 23

Contents Alpha Variable Speed Wet Polisher Table of Contents VSP-230 Overview SpecificationsComponents AccessoriesIntroduction About the SymbolsWork Area General Safety RulesElectrical Safety Personal SafetyTool USE and Care ServiceSpecific Safety Rules Grounding Instructions USE Proper Extension CordsCheck the working voltage Additional Precautions for Using the VSP-230Laws and Regulations of Noise Levels Be careful of your surroundings when working in high placesMain Connection Switching on and OFFVSP-230 Variable Speed WET Polisher Operation Gfci Information Ground Fault Circuit Interrupter GfciTesting IN-LINE Gfci Unit Before Each Use Of The Polisher Variable Speed AdjustmentWater Control Valve Speed POT Feedback SensorSide Handle Installation Recommended Heights Customizing the Splash GuardSplash Guard Installation WATER-FEED Attachment Profiler and Other Approved Spindle AttachmentsPeriodic MaintenanceDaily Bearings and Gears Carbon Brush ReplacementRear Cover Removal Page Spade Connector New Carbon Brush Clean Dirty Alpha VSP-230 Schematic Drawing no Description Quantity Alpha VSP-230 Parts ListRing Need More Information Services and Warranty Information Loaner ProgramWarranty Alpha Tool Repair ServiceEC Declaration of Conformity Appendix a Frequently Asked QuestionsHelpful Hints Product Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax