Schumacher SCF-6000A owner manual Personal Safety Precautions

Page 4

Never place charger directly above battery being charged. The gases from the battery will corrode and damage the charger.

Never touch the battery clamps together when the charger is on. You could cause a spark.

Never operate charger if it has received a hard blow, been dropped, or otherwise damaged. Take it to a qualified profes- sional for inspection and repair.

Be sure to position the charger power cord to prevent it from being stepped on, tripped over, or damaged.

Never pull out the plug by the cord when unplugging the SpeedCharge. Pulling on the cord may cause damage to the cord or the plug.

Do not operate the SpeedCharge if it has a damaged power cord or plug. Have the cord replaced.

PERSONAL SAFETY PRECAUTIONS

Wear complete eye and clothing protection when working with lead- acid batteries.

Make sure that someone is within range of your voice to come to your aid if needed while you work with or are near a lead-acid battery.

Have plenty of fresh water and soap nearby for use in case battery acid contacts your eyes, skin, or clothing. If this happens, wash immediately with soap and water. Then get medical attention.

Avoid touching your eyes while working with a battery. Acid particles (corrosion) may get into your eyes. If this occurs, flush eyes immediately with running cold water for at least 10 minutes. Then immediately get medical attention.

Never charge a frozen battery.

Remove all personal metal items from your body such as rings, bracelets, necklaces and watches, while working with a lead-acid battery. A battery can produce a short circuit current high enough to weld a ring (or the like) to metal, causing a severe burn.

Take care not to drop any metal tool or metal object onto the battery. This may spark or short circuit the battery or another electrical device that may cause an explosion.

Always operate the battery charger in an open, well-ventilated area.

Never smoke or allow a spark or flame in the vicinity of the battery or engine. Batteries generate explosive gases.

Neutralize any acid spills thoroughly with baking soda before attempting to clean up.

4

Image 4
Contents Send Warranty Product Repairs to Table of Contents Important Safety Instructions Help US Help YOUPersonal Safety Precautions Before Using Your Battery Charger Preparing Your Battery to be ChargedUsing AN Extension Cord Plugging ITCharging Battery in the Vehicle Connecting to a positive-groundedOperating Instructions Negative Grounded SystemCharging Battery Removed from the Vehicle Using Engine StartSCF-6000A Control Panel Display Mode Switch Charge Rate SwitchBattery Type Switch Speedcharge ControlSCF-6000A Control Panel Guide Control Panel GuideUsing the BUILT-IN Battery Tester Starting Sequence Using Your Engine StarterEngine Starting Notes Using Your Battery Charger 30A Charge Rate When set toCharging Tips General Charging NotesBattery Percent and Charge Time Maintenance and Care TroubleshootingProblem Possible Cause Solution Limited Warranty Manuel d’utilisation Faire parvenir les produits à réparer sous garantie àTable DES Matières Conservez CES Instructions Consignes DE Sécurité ImportantesAIDEZ-NOUS À Vous Aider Mesures DE Sécurité Personnelles Avant D’UTILISER LE Chargeur DE Batterie Préparer LA Batterie Pour LA ChargeBranchement Utilisation D’UNE RallongeConsignes D’UTILISATION Charge DE LA Batterie Dans LE Compartiment MoteurCircuit À Masse Négative Branchement à un circuit à masseCharge DE LA Batterie Hors DU Véhicule Circuit DE Démarrage ’URGENCECommutateur DE Taux DE Charge Tableau DE Commande DU ChargeurCommutateur DE Type DE Batterie Mode DE Fonctionnement Guide Tableau DE CommandeAffichage Numérique Utilisation DU Testeur DE Batterie Intégré Utilisation DU Circuit DE Démarrage D’URGENCE Séquence DE DémarrageUtilisation DU Chargeur DE Batterie Conseils Pour LA Charge Si votre véhicule refuse de démarrerPourcentage ET Temps DE Charge Tableau DE Dépannage Anomalie Cause Probable CorrectifEntretien Garantie Limitée