Sanyo 85464359982001 General, Outdoor Unit Part name, ’ty, Model 10 hp 16 hp

07-007 W-2WAY_II_NA 1/23/07 6:09 PM Page 8

1. GENERAL

This booklet briefly outlines where and how to install the air conditioning system. Please read over the entire set of instructions for the outdoor unit and make sure all accessory parts listed are with the system before beginning.

1-1. Tools Required for Installation (not supplied)

1.Standard screwdriver

2.Phillips head screwdriver

3.Knife or wire stripper

4.Tape measure

5.Carpenter’s level

6.Sabre saw or key hole saw

7.Hacksaw

8.Core bits

9.Hammer

10.Drill

11.Tube cutter

12.Tube flaring tool

13.Torque wrench

14.Adjustable wrench

15.Reamer (for deburring)

1-2. Accessories Supplied

See Tables 1-1 – 1-7.

Table 1-1 Outdoor Unit
Part name		Figure
	Outer	Inner
	diameter	diameter
Connection tubing	ø1-1/8"	ø1"
	Outer	Inner
	diameter	diameter
	ø7/8"	ø3/4"

1-3. Type of Copper Tube and Insulation Material

If you wish to purchase these materials separately from a local source, you will need:

1.Deoxidized annealed copper tube for refrigerant tubing.

2.Foamed polyethylene insulation for copper tubes as required to precise length of tubing. Wall thickness of the insulation should be not less than 5/16 in.

3.Use insulated copper wire for field wiring. Wire size varies with the total length of wiring.

Refer to “5. ELECTRICAL WIRING” for details.

Check local electrical codes and

CAUTION regulations before obtaining

wire. Also, check any specified instructions or limitations.

1-4. Additional Materials Required for Installation

1.Refrigeration (armored) tape

2.Insulated staples or clamps for connecting wire (See your local codes.)

3.Putty

4.Refrigeration tubing lubricant

5.Clamps or saddles to secure refrigerant tubing

6.Scale for weighing

	Q’ty
09053 Model	14053 Model
(10 hp)	(16 hp)
0	1
1	0

Instruction manual paper 1 1

(hp = horse power)

8