Ryobi P500 Cross CUTTING/RIP Cutting, TOP View of SAW Guideline Blade Guide Notch, Edge Clamp

CROSS CUTTING/RIP CUTTING

See Figure 16.

When making a cross cut or rip cut, align the line of cut with the outer blade guide notch on the base.

Since blade thicknesses vary, always make a trial cut in scrap material along a guideline to determine how much, if any, you must offset the guideline to produce an accurate cut.

NOTE: The distance from the line of cut to the guideline is the amount you should offset the guide.

RIP CUTTING

See Figure 17.

Use a guide when making long or wide rip cuts with the saw.

Secure the workpiece.

Clamp a straight edge to the workpiece using C-clamps.

Saw along the straight edge to achieve a straight rip cut.

NOTE: Do not bind the blade in the cut.

WIDTH OF CUT SCALE

See Figure 18.

A width of cut scale has been provided on the base of your saw. When making straight cross cuts or rip cuts, the scale can be used to measure up to four inches to the right side of the blade. It can be used to measure up to one inch to the left side of the blade.

TOP VIEW OF SAW	GUIDELINE
BLADE
GUIDE NOTCH
1
0
54
1
2
3	FRONT
4	OF SAW
	Fig. 16
	WORKPIECE
STRAIGHT
EDGE
0
5
5
40
5
30
2
2
	C-CLAMP

Fig. 17

WIDTH OF CUT
SCALE	Fig. 18

16