Bosch Power Tools DDH181X-01L Assembly, Inserting Bits, Drill BIT BIT Holder Screwdriver BIT

BM 2610032842 04-14_DDH181X HDH181X 4/9/14 7:10 AM Page 9

Assembly

Disconnect battery pack ! WARNING from tool before making

any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.

INSERTING BITS

Move reverse switch lever to the center “OFF” position. Remove battery pack and rotate the clutch ring to the drill bit symbol

“ ”. Rotate the chuck sleeve counter- clockwise viewing from chuck end, and open chuck to approximate drill bit diameter. Insert a clean bit up to the drill bit flutes for small bits, or as far as it will go for large bits. Close chuck by rotating the chuck sleeve clockwise and securely tighten by hand (Fig. 2).

Do not use the power of ! WARNING the drill while grasping

chuck to loosen or tighten bit. Friction burn or hand injury is possible if attempting to grasp the spinning chuck.

FIG. 2 CHUCK SLEEVE

DRILL BIT

BIT HOLDER

SCREWDRIVER BIT

AUxILIARy HANDLE

The tool must be supported with the auxiliary handle, which can be swiveled 320˚. To reposition and/or swivel the handle, loosen the

hand grip, move the handle to the desired position along the barrel and securely retighten the hand grip (Fig. 3 & 4).

FIG. 3 FIG. 4

1
	3	3
1		2
2		1

DEPTH GAUGE

Your drilling depth can be pre-set and/or repeated by using the depth gauge.

FIG. 5

1

2

-9-

Setting depth: After the auxiliary handle is installed, slide the depth gauge to desired depth and securely tighten wing knob (Fig. 5 & 6).

FIG. 6

3

X