BM 2610007872 12/09:BM 2610007872
GEAR SHIFTING
Your tool is equipped with two separate gear ranges, low gear and high gear. Low gear provides
ATTENTION: If your tool appears to be running, but the chuck will not turn, check to make sure the gear shifting switch is pushed fully into desired setting.
ADJUSTABLE CLUTCH
Your tool features 20 clutch settings. Output torque will increase as the clutch ring, is
rotated from 1 to 19. The drill “
” position will lock up the clutch to permit drilling and driving heavyduty work, and also enables bits to be changed quickly and easily in the keyless chuck (Fig. 7).
BRAKE
When the trigger switch is released it activates the brake to stop the chuck quickly. This is especially useful in the repetitive driving and removal of screws.
AUTOLOCK™
Your tool is equipped with an automatic locking system. This feature will lock the bit holder in one position when the trigger switch is released. This will allow you to tighten or loosen a nut or screw by rotating the tool by hand with the switch off. This is convenient when higher turning torque is needed.
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns on automatically when the switch is activated, for better visibility when drilling/driving (Fig. 7).
BATTERY CHARGE CONDITION
INDICATOR LIGHTS
Your tool is equipped with charge condition indicator lights (Fig. 1). The indicator lights shows the charge condition of the battery for a few second when the On/Off trigger is pressed halfway or fully.
LED | Capacity |
Continuous lighting 3 x green | > 2/3 |
Continuous lighting 2 x green | > 1/3 |
Continuous lighting 1 x green | < 1/3 |
Flashing light 1 x green | reserve |
INSERTING AND RELEASING
BATTERY PACK
Release battery pack from tool by pressing on both sides of the battery release tabs and pull downward (Fig. 4).
To insert battery, align battery and slide battery pack into tool until it locks into position. Do not force.
If battery release tabs are ! WARNING cracked or otherwise damaged, do not insert into tool. Battery
can fall out during operation.
FIG. 4
BATTERY
RELEASE
TABS
IMPORTANT CHARGING NOTES
1.The charger was designed to fast charge the battery only when the battery temperature is between 32˚F (0˚C) and 113˚F (45˚C). If the battery pack is too hot or too cold, the charger will not fast charge the battery. (This may happen if the battery pack is hot from heavy use). When the battery temperature returns to between 32˚F (0˚C) and 113˚F (45˚C), the charger will automatically begin charging.
2.A substantial drop in operating time per charge may mean that the battery pack is nearing the end of its life and should be replaced.
3.Remember to unplug charger during storage period.
4.If battery does not charge properly:
a. Check for voltage at outlet by plugging in some other electrical device.