Bosch Appliances D9412GV3 manual # Delay Restorals, # Exit Tone, # Exit Dly Time, # Auto Watch

D9412GV3/D7412GV3 Program Entry Guide 2.0 Panel and Area Wide Parameters

EN 38

Refer to the prompts P## Force Arm Returnable and P## Bypass Returnable in Section 3.2 Point Responses on page 91 for returning a point to the system when the point returns to normal or when the area is disarmed.

Users can bypass more points than the number entered here during the disarmed state. It is only when the user attempts to Bypass Arm an area (or areas) that this restriction is enforced.

A# Delay Restorals

Default:	No
Selection:	Yes or No
Yes	Point Restoral Report is not sent until
	the bell time expires or user
	acknowledges alarm condition.
No	Restoral Reports are sent when point
	restores, regardless of bell time.

A# Exit Tone

Default: Yes

Selection: Yes or No

Sounds an exit tone during exit delay at all keypads assigned to this area.

You can turn off exit tones for individual keypads by programming the appropriate CC# 1 to 8 as No in CC# Exit Tone.

A# Exit Dly Time

Default: 60

Selection: 0 to 600 ( in 5 sec increments)

Exit delay time for this area when Master Exit or Perimeter Exit arming.

Points programmed for instant alarm response generate alarms immediately, even during exit delay. To avoid instant alarms on points adjacent to the perimeter when leaving the area, program P## Type as 3 (Interior Follower).

For SIA CP-01 Compliance

The Exit Delay Time must be between 45 sec and 255 sec.

A# Auto Watch

Default: No

Selection: Yes or No

Yes		When the area is disarmed, Watch
		Mode turns on automatically.
No		When the area is disarmed, Watch
		Mode must be turned on or off
		manually.
	Controlled points must be programmed
	as P## Watch Point to generate a
	watch tone.

A# Verify Time

Default: 60

Selection: 10 to 60 (in 1-sec increments)

Use alarm verification with smoke detectors to reduce the number of false fire alarms. When Verify Time is programmed, the control panel can check smoke detector point activations before generating alarm signals.

 Do not enable the Cross Point feature in point indexes designated for Fire points.

Check with your authority having jurisdiction (AHJ) to determine the maximum verification time allowed.

Points are programmed individually to activate the verification feature. Refer to Section 3.1 Point Index on page 87. Any resettable Fire point can activate alarm verification for the area to which it is assigned. Use separate area alarm-verification relays.

To enable alarm verification on a point, program Point Index, Fire Point, Alarm Verify, and Resettable as Yes.

When an Alarm Verification point senses an alarm, the control panel automatically removes power to all Resettable points connected to the area’s Reset Sensors relay. The sensor reset removes power to the sensors for the amount of time programmed in Verify Time. When power is reapplied, a 60-sec confirmation window begins. If the detector is still in alarm and experiences another alarm during the confirmation window, or a different Resettable Verification point in the area senses an alarm, an alarm occurs.

Example: Verify Time is set for 20 sec. The alarm verification cycle starts when the detector senses smoke or fire. No report occurs.

Bosch Security Systems, Inc. 10/11 F01U170807-02