Dell manual Installing the Perc H200 Modular Card

Installing the PERC H200 Modular Card

NOTE: For more information on removing and installing blade system parts, see your system’s Hardware Owner’s Manual or the User’s Guide from the Dell Support website at support.dell.com.

The storage controller card is located below the hard drive bays of the Dell Blade system.

To remove the storage controller card:

1Remove the Dell Blade system from the Blade system chassis.

2Remove the system cover of the Blade system.

3Remove the system board and place it on a stable and flat surface.

4Open the release lever to disconnect the storage controller card edge connector from the system board connector as illustrated in Figure 4-4.

5Lift the storage controller card straight up from the system board as illustrated in Figure 4-4.

Figure 4-4. Removing and Installing the Storage Controller Card

1

2

1 storage controller card 2 release lever

Hardware Installation

29