Dell H200 manual Configuration Utility Error Messages, For Configuration Utility

Configuration Utility Error Messages

NOTE: These error messages are displayed inside the Configuration Utility. Restart your system and retry if you encounter any of these.

NOTE: If the error message continues to be displayed even after following the steps mentioned in Table 7-3 for the resolution of the error, contact Dell Support for advanced troubleshooting. For information on how to contact Dell Technical Support, see "Getting Help" on page 73.

Table 7-3. Configuration Utility Error Messages

Message	Meaning	Suggested Solution
An error occurred	An error occurred while	Reseat the controller
while reading	reading any one of a	and reboot.
non-volatile	number of settings from
settings.	the firmware.
An error occurred	Controller setup and	Reboot the system.
while reading current	initialization has failed.
controller settings.
Advanced Device	Failed to read vital	Reflash the firmware
Properties settings	configuration page from	and reboot.
not found.	firmware.
Error obtaining	Failed to read vital	Reflash the firmware
PHY properties	configuration page from	and reboot.
configuration	firmware.
information.

Configuration Utility	Failed to properly read
Options Image	Configuration Utility
checksum error.	options from flash.

Restart and retry. If the issue persists, reflash the firmware on the controller.

Can't load default	Failed to allocate memory
Configuration	for Configuration Utility
Utility options.	options structure.
An error occurred	An error occurred while
while writing	writing one or more settings
non-volatile	to the firmware.
settings.

64

Troubleshooting