Tefal GV6920Z0, GV6920E0, GV6920C0 manual Use, Using your steam station, Steam ironing, Dry ironing

1800129574 GV69XX E0 A11_110x154 18/04/13 15:59 Page22

The first time the appliance is used, there may be some fumes and smell but this is not harmful. They will not affect use and will disappear rapidly.

Using your steam station

•Completely unwind the power cord and the steam cord from its storage space .

•Tilt the locking ring of the iron forwards to release the safety catch.

•Plug in your steam station to an earthed socket.

•Press the on/off luminous switch. It comes on and the boiler heats up.

•After approximately 8 minutes or when the steam ready indicator light comes on (accor- ding to model), the steam is ready - fig.5.

•During ironing the iron’s thermostat light and the steam indicator (according to model) will go on and off according to the temperature control.

•When starting, and regularly while it is being used, your steam generator's electric pump in- jects water into the boiler. It makes a noise but this is quite normal. You may also hear a clicking noise which is the steam valve opening. Again this is normal.

Use

Steam ironing

•Set the iron temperature adjustment dial and the steam flow adjustment dial (according to model) to the type of fabric to be ironed (see table below).

•The thermostat light comes on. Important: whenever you start using your iron and whe- never you reduce the temperature during use, the iron is ready for use when its indica- tor light goes out and when the green light located on the control panel comes on and remains on. During use, when you increase the temperature of the iron, you can start ironing immediately, but make sure you only increase your steam flow once the iron’s light has gone out.

•To obtain steam, press on the steam control button on the iron handle - fig.6.

The steam station and the iron are ready to iron when the steam ready indi- cator light (accor- ding to model) is lit and the iron ther- mostat dial light has gone out.

YPET OF FABRICS		SETTING TEMPERATURE	SETTING STEAM OUTPUT CONTROL DIAL
		CONTROL
Silk, Synthetics		•
(polyester, acetate, acrylic,
polyamide)
Silk, Wool		••
Linen, cotton		•••
Mixed fibre fabrics : set the	• The steam will stop when you release the button.
	• Start with the fabrics to be ironed at a low temperature and finish with those
ironing temperature to the
	which need higher temperatures (••• or Max).
setting for the most delicate
	• To prime the steam circuit, either before using the iron for the first time, or if you
fabric. Woollen garments :
	have not used the steam function for a few minutes, press the steam control but-
press repeatedly on the
	ton - fig.6. several times in a row, holding the iron away from your clothes.This will
steam control button - fig.6
	enable any cold water to be removed from the steam circuit.
to obtain short bursts of
	• For delicate fabrics, press the steam control button (on the handle of the iron) in-
steam, without placing the
	termittently to avoid possible water droplets appearing with the steam.
iron on the garment itself.

This will avoid making the fa- • If you are using starch, it should be sprayed onto the reverse side of the fabric to

bric shiny.	be ironed.
	• If you put your thermostat in the “min” position, the iron does not become hot.
		Dry ironing
	• Do not press on the steam control button - fig.6.

22