HP J3177A, J3175A manual Verify the Switch’s Operation

Installing the Switch 208/224

Installing the Switch 208/224

Installation Steps

3. Verify the Switch’s Operation

After you have installed any modules, but before mounting the switch in its network location, you should first verify that it is working properly by plugging it into a power source and verifying that it passes its self test.

1.Connect the power cord supplied with the switch to the power connector on the back of the switch, and then into a properly grounded electrical outlet.

				Connect power cord to
				power connector.
N o t e	The Switch 208/224 does not have a power switch. It is powered on when the
	power cord is connected to the switch and to a power source.
	If your installation requires a different power cord than the one supplied with
	the switch, be sure to use a power cord displaying the mark of the safety
	agency that defines the regulations for power cords in your country. The mark
	is your assurance that the power cord can be used safely with the switch.
	2. Check the LEDs on the switch’s front panel (and on the Switch Manage-
		ment Module, if one is installed in the switch). The LED behavior is
		described on the next page.
			switch LEDs

Switch Management Module LEDs

1-6