HP J3177A, J3175A manual Management Slot, Management Module Features

Page 30

Switch 208/224 Description

Switch 208/224 Description

Front of the Switches

LED

State

Meaning

 

 

 

10 Mbit/s Ports

 

 

 

 

 

Port Number

Off

The port is not receiving the link beat signal from the attached node or the port is

 

 

disabled.

 

 

 

 

On

The port is enabled and link beat is detected from the attached node.

 

 

 

 

Flickering

Indicates activity on the port.

 

 

 

* The slow flash behavior is a regular pulse once every 1.6 seconds, approximately.

Management Slot

The Management Slot in the front of the switch allows you to install an HP Switch 208/224 Management Module. When installed, the Switch Management Module adds these features to your switch:

Management Module Features

Access to the switch console from which you can configure, monitor, and troubleshoot the switch

Access to the switch from SNMP network management programs, such as HP AdvanceStack Assistant, for controlling the switch using an advanced, graphics-based interface

Configurable full-duplex port operation

Configurable support for the Spanning Tree Protocol for switched networks

Configurable MAC Address Table aging

For more information on the HP Switch 208/224 Management Module, contact your HP-authorized LAN reseller, or you can find out about HP switches and their accessories, and other HP networking products by visiting the World Wide Web site http://www.hp.com/go/network_city .

2-4

Image 30
Contents HP AdvanceStack Switch 208/224 Page HP FTP Library Service HP Customer Support ServicesHow to get the latest software/agent firmware World Wide WebHP First Fax Retrieval Service Additional HP Support ServicesLocation Phone Number HP AdvanceStack Switch 208/224 Installation and Reference GuidePublication Number Contents Index Installing the Switch 208/224 Installing the Switch 208/224Installation Steps Installing the Switch 208/224Included Parts Prepare the Installation Site Installation PrecautionsInstall Any Optional Modules Installing ModulesInstalling Transceivers 100Base-T transceiver modules into the Switch 208/224Do not install any 100VG transceiver modules in this slot Verify the Switch’s Operation When the self test completes successfully LED BehaviorMount the Switch Mounting the Switch in a Rack or CabinetInsert a screw into the top hole of a close 0.5-inch Install additional screw Mounting the Switch on a Wall Mounting the Switch on a Horizontal SurfaceConnect the Switch to a Power Source 100Base-T Xcvr Slot Using RJ-45 Connectors 10 Mbit/s and 100 Mbit/s portsConnect the Network Cables To connectSwitch 208/224 Condition Diagnostic Tip InstallingAs a Segment Switch Switch 208TSample Network Topologies As a Desktop Switch Switch 224T PCs and peripheralsServer Switch Connecting to a Backbone SwitchFddi Campus Backbone Installing the Switch 208/224 Switch 224T Switch 208TWhere to Go From Here Cable ManagementSwitch 208/224 Description FeaturesFront of the Switches Switch 208/224 DescriptionNetwork Ports LEDs State MeaningManagement Module Features Management SlotRedundant Power Supply RPS Connector Back of the SwitchesPower Connectors Expansion SlotSwitch Operation Address Table OperationSimultaneous Network Communications Page Troubleshooting Solutions to Common ProblemsTroubleshooting Wrong network speed connected -- You have connected aLED Error Indications Diagnostic TipsDiagnostic Tests Testing the SwitchTesting Twisted-Pair Cabling Testing End-to-End Network Communications Testing Switch-to-Device Network CommunicationsResetting the Switch HP BBSCables and Connectors Twisted-Pair Cable/Connector Pin-OutsCables and Connectors White/orange Twisted-Pair Straight-Through Cable Fiber-Optic CablesTwisted-Pair Cable Pin Assignments Twisted-Pair Cross-Over CableElectrical SpecificationsPhysical EnvironmentalSpecifications ConnectorsSafety ElectromagneticSafety and Regulatory Statements Mounting PrecautionsPower Precautions Safety and Regulatory StatementsSafety Information GroundingServicing Informations concernant la sécurité Tible de causer des dommages à léquipementHinweise zur Sicherheit Considerazioni sulla sicurezza AttrezzatureConsideraciones sobre seguridad Resultar en averías al equipoSafety Information Japanese European Community Regulatory StatementsFCC Class a Statement for U.S.A. Only CanadaDeclaration of Conformity Index NumericsMounting switch on … 1-11 HP Redundant Power Supply RPS Rack Page Page 5966-5225