HP Ethernet BL-c manual Component identification, 110Gb Ethernet Blade Switch front panel

Page 16

Component identification

In this section
1:10Gb Ethernet Blade Switch front panel	16

1:10Gb Ethernet Blade Switch front panel

	CAUTION: Pressing the Reset button while the Health LED is green resets the switch.

Item	Description

1	UID LED

2	Health LED
	• Off—Not powered up
	• Green—Powered up and all ports match
	• Amber—Indicates a problem such as a port mismatch. For more
	information, see the HP BladeSystem enclosure setup and
	installation guide.

3	DB-9 management serial port

4	CX4 connector port 19
	• Link LED (top)—Green
	• Activity LED (bottom)—Flashing green

5	XFP transceiver cage port 20
	• Link LED (top)—Green
	• Activity LED (bottom)—Flashing green
		Component identification 16
		Component identification 16

Image 16

Contents HP 110Gb Ethernet BL-c Switch User Guide Audience assumptions Contents Replacing a switch Acronyms and abbreviations Index Features IntroductionAdditional references Enterprise class performanceIntroduction Switch redundancy Configuration and managementDiagnostic tools Switch architecturePort Mapping Dual switches Layer 2 switching Layer 3 switchingSupported technologies Redundant crosslinksIeee 802.1 Q-based Vlan Spanning Tree ProtocolStore and forward switching scheme Port mirroringPort trunking and load balancing Tftp supportRadius SSH and SCP XModemIgmp Snooping Jumbo framesRedundant images in firmware 110Gb Ethernet Blade Switch front panel Component identificationGreen-Link LED top Installing the switch Preparing for installationPlanning the switch configuration Default settingsSwitch security User, operator, and administrator access rightsManually configuring a switch Configuring multiple switchesInstalling the switch Accessing the switch Logging on and configuring the switch Installing XFP transceivers Supporting software and special considerationsInstalling the switch Replacing a switch Replacing an existing switchReplacing a switch Regulatory compliance notices Class a equipmentModifications CablesEuropean Union regulatory notice Bsmi notice Japanese class a noticeKorean class a notice Laser compliance Technical specifications General specificationsPort names, VLANs, STP, trunking default settings STPRuntime switching software default settings General default settingsSTP Algorithm Setting Value Mstp UFD Igmp Physical and environmental specifications Performance specificationsCategory Specification Performing a serial download Serial upgrade of boot code firmware image procedureIntroduction Performing a serial download Performing a serial download Serial upgrade of operating system firmware procedure 10G100.binPerforming a serial download Performing a serial download MIB overview Snmp MIBs supportSnmp Manager software Supported MIBs Supported trapsSnmp MIBs support Preventing electrostatic discharge Electrostatic dischargeGrounding methods to prevent electrostatic discharge RJ-45 pin specification Standard RJ-45 receptacle/connectorRJ-45 signals RJ-45 pins DB-9 pins DB-9 signals Troubleshooting Health LED on the switch is not onTroubleshooting Bootp Page Troubleshooting Troubleshooting XFP transceiver port is disabled Switch configuration is corruptDownload fails after starting to download the firmware file Acronyms and abbreviations Ieee NTP SCP Index Switch self-test, troubleshooting