HP Ethernet BL-c manual Setting Value

Page 36

Setting	Value

Serial Port Parity Bit	None

Serial Port Stop Bit	1

Serial Port Flow Control	None

Default VLAN	Default VLAN (VID=1) with all ports assigned including CPU, STG=1

NTP State	Disabled

NTP Server	0.0.0.0

NTP Resync Interval	720 minutes

GMT Timezone Offset	-06:00

Daylight Savings Time	Disabled
State

System Up Time	0 days 00 :00 :00

Current time	RTC or NTP (00 :00 :00)

Date	None

Syslog Host	0.0.0.0

Syslog Host 2	0.0.0.0

Syslog Host Severity	7

Syslog Host 2 Severity	7

Syslog Console Output	Disabled

Log	•	console—Enabled
	•	system—Enabled
	•	mgmt—Enabled
	•	cli—Enabled
	•	stp—Enabled
	•	vlan—Enabled
	•	ssh—Enabled
	•	ntp—Enabled
	•	ip—Enabled
	•	web—Enabled

RSA Server Key Autogen	0
Interval

RSA Server Key Autogen	Disabled

SSH Server	On

SCP-only Administrator	admin
Password

SSH Server Port	22

SCP Apply and Save	Disabled

RADIUS Server	Off

RADIUS Secret	None

Primary RADIUS Server	0.0.0.0

Secondary RADIUS Server	0.0.0.0

Technical specifications 36

Image 36

Contents HP 110Gb Ethernet BL-c Switch User Guide Audience assumptions Contents Replacing a switch Acronyms and abbreviations Index Features IntroductionAdditional references Enterprise class performanceIntroduction Switch redundancy Configuration and managementSwitch architecture Diagnostic toolsPort Mapping Dual switches Layer 2 switching Layer 3 switchingSupported technologies Redundant crosslinksIeee 802.1 Q-based Vlan Spanning Tree ProtocolStore and forward switching scheme Port mirroringPort trunking and load balancing Tftp supportRadius SSH and SCP XModemIgmp Snooping Jumbo framesRedundant images in firmware 110Gb Ethernet Blade Switch front panel Component identificationGreen-Link LED top Installing the switch Preparing for installationPlanning the switch configuration Default settingsSwitch security User, operator, and administrator access rightsManually configuring a switch Configuring multiple switchesInstalling the switch Accessing the switch Logging on and configuring the switch Installing XFP transceivers Supporting software and special considerationsInstalling the switch Replacing a switch Replacing an existing switchReplacing a switch Regulatory compliance notices Class a equipmentModifications CablesEuropean Union regulatory notice Bsmi notice Japanese class a noticeKorean class a notice Laser compliance Technical specifications General specificationsPort names, VLANs, STP, trunking default settings STPRuntime switching software default settings General default settingsSTP Algorithm Setting Value Mstp UFD Igmp Physical and environmental specifications Performance specificationsCategory Specification Serial upgrade of boot code firmware image procedure Performing a serial downloadIntroduction Performing a serial download Performing a serial download Serial upgrade of operating system firmware procedure 10G100.binPerforming a serial download Performing a serial download Snmp MIBs support MIB overviewSnmp Manager software Supported MIBs Supported trapsSnmp MIBs support Electrostatic discharge Preventing electrostatic dischargeGrounding methods to prevent electrostatic discharge RJ-45 pin specification Standard RJ-45 receptacle/connectorRJ-45 signals RJ-45 pins DB-9 pins DB-9 signals Troubleshooting Health LED on the switch is not onTroubleshooting Bootp Page Troubleshooting Troubleshooting Switch configuration is corrupt XFP transceiver port is disabledDownload fails after starting to download the firmware file Acronyms and abbreviations Ieee NTP SCP Index Switch self-test, troubleshooting