HP Ethernet BL-c manual Serial upgrade of operating system firmware procedure, 10G100.bin

Page 45

Serial upgrade of operating system firmware procedure

To perform a serial upgrade of the switch operating system firmware image, usually named GbE2c-1-

10G_100.bin:

1.Using the null modem cable, connect the console port of the switch to the serial port of a PC that supports XModem/1K XModem.

2.Start HyperTerminal (part of Microsoft Windows) or equivalent terminal emulation application (depending on the computer operating system) and set the parameters for terminal emulation console:

Parameter	Value

Baud rate	9600

Data bits	8

Parity	None

Stop bits	1

Flow control	None

3.Power on the switch.

4.Hold down the Shift key and press the D key repeatedly during the Memory Test, until this message appears:

Performing a serial download 45

Image 45

Contents HP 110Gb Ethernet BL-c Switch User Guide Audience assumptions Contents Replacing a switch Acronyms and abbreviations Index Introduction FeaturesAdditional references Enterprise class performanceIntroduction Configuration and management Switch redundancySwitch architecture Diagnostic toolsPort Mapping Dual switches Layer 3 switching Layer 2 switchingSupported technologies Redundant crosslinksSpanning Tree Protocol Ieee 802.1 Q-based VlanPort mirroring Store and forward switching schemePort trunking and load balancing Tftp supportRadius XModem SSH and SCPIgmp Snooping Jumbo framesRedundant images in firmware Component identification 110Gb Ethernet Blade Switch front panelGreen-Link LED top Preparing for installation Installing the switchPlanning the switch configuration Default settingsUser, operator, and administrator access rights Switch securityConfiguring multiple switches Manually configuring a switchInstalling the switch Accessing the switch Logging on and configuring the switch Supporting software and special considerations Installing XFP transceiversInstalling the switch Replacing an existing switch Replacing a switchReplacing a switch Class a equipment Regulatory compliance noticesModifications CablesBsmi notice Japanese class a notice European Union regulatory noticeKorean class a notice Laser compliance General specifications Technical specificationsSTP Port names, VLANs, STP, trunking default settingsGeneral default settings Runtime switching software default settingsSTP Algorithm Setting Value Mstp UFD Igmp Performance specifications Physical and environmental specificationsCategory Specification Serial upgrade of boot code firmware image procedure Performing a serial download Introduction Performing a serial download Performing a serial download 10G100.bin Serial upgrade of operating system firmware procedurePerforming a serial download Performing a serial download Snmp MIBs support MIB overviewSnmp Manager software Supported traps Supported MIBsSnmp MIBs support Electrostatic discharge Preventing electrostatic dischargeGrounding methods to prevent electrostatic discharge Standard RJ-45 receptacle/connector RJ-45 pin specificationRJ-45 signals RJ-45 pins DB-9 pins DB-9 signals Health LED on the switch is not on TroubleshootingTroubleshooting Bootp Page Troubleshooting Troubleshooting Switch configuration is corrupt XFP transceiver port is disabledDownload fails after starting to download the firmware file Acronyms and abbreviations Ieee NTP SCP Index Switch self-test, troubleshooting