8.Select
The Send File window displays progress of the file transfer. The file transfer might take up to seven minutes.
NOTE: Although slower, XModem also works if 1K MODEM is not used.
9.After completing the transfer, a message displays how many bytes transferred, followed by another message displaying the status of image extraction. Do not power cycle the switch during this process. After extracting the image, it is updated to flash and a message with a progress indicator displays as shown.
CAUTION: Do not power off the switch until the message: "Change your baud rate to 9600 bps and power cycle the switch," is displayed, otherwise, the switch will be inoperable.
10.Change the baud rate to 9600 and power off the switch, wait for a few seconds, and power on the switch.
The switch boots with the new version of the boot code image that was just downloaded.