HP Ethernet BL-c manual Supported MIBs, Supported traps

Page 49

Supported MIBs

The SNMP agent for the switch supports these MIBs:

•dot1x.mib

•GbE2c-1-10G-L2L3.mib

•GbE2c-1-10G-L2L3_cpqhost.mib

•GbE2c-1-10G-L2L3_cpqrack.mib

•GbE2c-1-10G-L2L3_cpqsinfo.mib

•rfc1213.mib

•rfc1215.mib

•rfc1493.mib

•rfc1573.mib

•rfc1643.mib

•rfc1757.mib

•rfc1907.mib

•rfc2037.mib

•rfc2571.mib

•rfc2572.mib

•rfc2573.mib

•rfc2574.mib

•rfc2575.mib

•rfc2576.mib

Supported traps

The switch SNMP agent supports these traps:

•rfc1215.mib traps o coldStart

o warmStart o linkDown o linkUp

o authenticationFailure o egpNeighborLoss

•rfc1493.mib traps o newRoot

o topologyChange

•rfc1757.mib traps

SNMP MIBs support 49

Image 49

Contents HP 110Gb Ethernet BL-c Switch User Guide Audience assumptions Contents Replacing a switch Acronyms and abbreviations Index Introduction FeaturesAdditional references Enterprise class performanceIntroduction Configuration and management Switch redundancyDiagnostic tools Switch architecturePort Mapping Dual switches Layer 3 switching Layer 2 switchingSupported technologies Redundant crosslinksSpanning Tree Protocol Ieee 802.1 Q-based VlanPort mirroring Store and forward switching schemePort trunking and load balancing Tftp supportRadius XModem SSH and SCPIgmp Snooping Jumbo framesRedundant images in firmware Component identification 110Gb Ethernet Blade Switch front panelGreen-Link LED top Preparing for installation Installing the switchPlanning the switch configuration Default settingsUser, operator, and administrator access rights Switch securityConfiguring multiple switches Manually configuring a switchInstalling the switch Accessing the switch Logging on and configuring the switch Supporting software and special considerations Installing XFP transceiversInstalling the switch Replacing an existing switch Replacing a switchReplacing a switch Class a equipment Regulatory compliance noticesModifications CablesBsmi notice Japanese class a notice European Union regulatory noticeKorean class a notice Laser compliance General specifications Technical specificationsSTP Port names, VLANs, STP, trunking default settingsGeneral default settings Runtime switching software default settingsSTP Algorithm Setting Value Mstp UFD Igmp Performance specifications Physical and environmental specificationsCategory Specification Performing a serial download Serial upgrade of boot code firmware image procedureIntroduction Performing a serial download Performing a serial download 10G100.bin Serial upgrade of operating system firmware procedurePerforming a serial download Performing a serial download MIB overview Snmp MIBs supportSnmp Manager software Supported traps Supported MIBsSnmp MIBs support Preventing electrostatic discharge Electrostatic dischargeGrounding methods to prevent electrostatic discharge Standard RJ-45 receptacle/connector RJ-45 pin specificationRJ-45 signals RJ-45 pins DB-9 pins DB-9 signals Health LED on the switch is not on TroubleshootingTroubleshooting Bootp Page Troubleshooting Troubleshooting XFP transceiver port is disabled Switch configuration is corruptDownload fails after starting to download the firmware file Acronyms and abbreviations Ieee NTP SCP Index Switch self-test, troubleshooting