HP Ethernet BL-c manual Audience assumptions

Page 2

© Copyright 2007 Hewlett-Packard Development Company, L.P.

The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.

Microsoft, Windows, and Windows NT are U.S. registered trademarks of Microsoft Corporation. Windows Server 2003 is a trademark of Microsoft Corporation. Intel, Pentium, and Itanium are trademarks or registered trademarks of Intel Corporation or its subsidiaries in the United States and other countries. UNIX is a registered trademark of The Open Group.

Audience assumptions

This document is for the person who installs, administers, and troubleshoots servers and storage systems. HP assumes you are qualified in the servicing of computer equipment and trained in recognizing hazards in products with hazardous energy levels.

Image 2
Contents HP 110Gb Ethernet BL-c Switch User Guide Audience assumptions Contents Replacing a switch Acronyms and abbreviations Index Additional references FeaturesIntroduction Enterprise class performanceIntroduction Switch redundancy Configuration and managementPort Mapping Dual switches Switch architectureDiagnostic tools Supported technologies Layer 2 switchingLayer 3 switching Redundant crosslinksIeee 802.1 Q-based Vlan Spanning Tree ProtocolPort trunking and load balancing Store and forward switching schemePort mirroring Tftp supportRadius Igmp Snooping SSH and SCPXModem Jumbo framesRedundant images in firmware 110Gb Ethernet Blade Switch front panel Component identificationGreen-Link LED top Planning the switch configuration Installing the switchPreparing for installation Default settingsSwitch security User, operator, and administrator access rightsManually configuring a switch Configuring multiple switchesInstalling the switch Accessing the switch Logging on and configuring the switch Installing XFP transceivers Supporting software and special considerationsInstalling the switch Replacing a switch Replacing an existing switchReplacing a switch Modifications Regulatory compliance noticesClass a equipment CablesEuropean Union regulatory notice Bsmi notice Japanese class a noticeKorean class a notice Laser compliance Technical specifications General specificationsPort names, VLANs, STP, trunking default settings STPRuntime switching software default settings General default settingsSTP Algorithm Setting Value Mstp UFD Igmp Physical and environmental specifications Performance specificationsCategory Specification Introduction Serial upgrade of boot code firmware image procedurePerforming a serial download Performing a serial download Performing a serial download Serial upgrade of operating system firmware procedure 10G100.binPerforming a serial download Performing a serial download Snmp Manager software Snmp MIBs supportMIB overview Supported MIBs Supported trapsSnmp MIBs support Grounding methods to prevent electrostatic discharge Electrostatic dischargePreventing electrostatic discharge RJ-45 pin specification Standard RJ-45 receptacle/connectorRJ-45 signals RJ-45 pins DB-9 pins DB-9 signals Troubleshooting Health LED on the switch is not onTroubleshooting Bootp Page Troubleshooting Troubleshooting Download fails after starting to download the firmware file Switch configuration is corruptXFP transceiver port is disabled Acronyms and abbreviations Ieee NTP SCP Index Switch self-test, troubleshooting