HP Ethernet BL-c manual Korean class a notice Laser compliance

Page 30

Korean class A notice

Laser compliance

This product may be provided with an optical storage device (that is, CD or DVD drive) and/or fiber optic transceiver. Each of these devices contains a laser that is classified as a Class 1 Laser Product in accordance with US FDA regulations and the IEC 60825-1. The product does not emit hazardous laser radiation.

Each laser product complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated May 27, 2001; and with IEC 60825-1:1993/A2:2001.

WARNING: Use of controls or adjustments or performance of procedures other than those specified herein or in the laser product's installation guide may result in hazardous radiation exposure. To reduce the risk of exposure to hazardous radiation:

Do not try to open the module enclosure. There are no user-serviceable components inside.

Do not operate controls, make adjustments, or perform procedures to the laser device other than those specified herein.

Allow only HP Authorized Service technicians to repair the unit.

The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration implemented regulations for laser products on August 2, 1976. These regulations apply to laser products manufactured from August 1, 1976. Compliance is mandatory for products marketed in the United States.

Regulatory compliance notices 30

Image 30
Contents HP 110Gb Ethernet BL-c Switch User Guide Audience assumptions Contents Replacing a switch Acronyms and abbreviations Index Additional references FeaturesIntroduction Enterprise class performanceIntroduction Switch redundancy Configuration and managementSwitch architecture Diagnostic toolsPort Mapping Dual switches Supported technologies Layer 2 switchingLayer 3 switching Redundant crosslinksIeee 802.1 Q-based Vlan Spanning Tree ProtocolPort trunking and load balancing Store and forward switching schemePort mirroring Tftp supportRadius Igmp Snooping SSH and SCPXModem Jumbo framesRedundant images in firmware 110Gb Ethernet Blade Switch front panel Component identificationGreen-Link LED top Planning the switch configuration Installing the switchPreparing for installation Default settingsSwitch security User, operator, and administrator access rightsManually configuring a switch Configuring multiple switchesInstalling the switch Accessing the switch Logging on and configuring the switch Installing XFP transceivers Supporting software and special considerationsInstalling the switch Replacing a switch Replacing an existing switchReplacing a switch Modifications Regulatory compliance noticesClass a equipment CablesEuropean Union regulatory notice Bsmi notice Japanese class a noticeKorean class a notice Laser compliance Technical specifications General specificationsPort names, VLANs, STP, trunking default settings STPRuntime switching software default settings General default settingsSTP Algorithm Setting Value Mstp UFD Igmp Physical and environmental specifications Performance specificationsCategory Specification Serial upgrade of boot code firmware image procedure Performing a serial downloadIntroduction Performing a serial download Performing a serial download Serial upgrade of operating system firmware procedure 10G100.binPerforming a serial download Performing a serial download Snmp MIBs support MIB overviewSnmp Manager software Supported MIBs Supported trapsSnmp MIBs support Electrostatic discharge Preventing electrostatic dischargeGrounding methods to prevent electrostatic discharge RJ-45 pin specification Standard RJ-45 receptacle/connectorRJ-45 signals RJ-45 pins DB-9 pins DB-9 signals Troubleshooting Health LED on the switch is not onTroubleshooting Bootp Page Troubleshooting Troubleshooting Switch configuration is corrupt XFP transceiver port is disabledDownload fails after starting to download the firmware file Acronyms and abbreviations Ieee NTP SCP Index Switch self-test, troubleshooting