HP 5120 EI, 5120 SI, 5120 48G, E5500-48-POE Setting terminal parameters, Connection description

2.Connect the RJ-45 connector to the console port of the switch.

NOTE:

•Identify the mark on the console port and make sure that you are connecting to the correct port.

•The serial ports on PCs do not support hot swapping. If the switch has been powered on, connect the console cable to the PC before connecting to the switch, and when you disconnect the cable, first disconnect from the switch.

Setting terminal parameters

To configure and manage the switch, you must run a terminal emulator program on the console terminal. The following are the required terminal settings:

•Bits per second—9,600

•Data bits—8

•Parity—None

•Stop bits—1

•Flow control—None

•Emulation—VT100

To set terminal parameters, for example, on a Windows XP HyperTerminal:

1.Select Start > All Programs > Accessories > Communications > HyperTerminal. The Connection Description dialog box appears.

2.Enter the name of the new connection in the Name field and click OK.

Figure 71 Connection description

3.Select the serial port to be used from the Connect using list, and click OK.

45