HP 5120 SI Fan failure only for the 5120 EI switches, Configuration terminal problems, Mark State

NOTE:

If the problem persists, contact the HP technical support for help.

Fan failure (only for the 5120 EI switches)

You can look at the system status LED and the seven-segment LED of a 5120 EI switch to identify a fan failure. If both LEDs are behaving as described in Table 14, a fan failure occurs.

Table 14 LED behaviors that identify a fan failure

LED	Mark	State
System status LED	PWR	Steady red
		The LED flashes F for fan failure.
Seven-segment LED	Unit

The 5120 EI switches use fixed fans. If a fan failure occurs, contact the HP technical support for help and do not attempt to fix the problem yourself.

Configuration terminal problems

If the configuration environment setup is correct, the configuration terminal displays booting information when the switch is powered on. If the setup is incorrect, the configuration terminal would display nothing or garbled text.

No terminal display

If the configuration terminal displays nothing after the switch is powered on, verify the following items:

•The power supply is supplying power to the switch.

•The console cable is properly connected.

•The console cable has no problem and the terminal settings are correct.

Garbled terminal display

If terminal display is garbled, verify that the following settings are configured for the terminal, for example, HyperTerminal:

•Baud rate—9,600

•Data bits—8

•Parity—none

•Stop bits—1

•Flow control—none

•Emulation—VT100

63