HP Raining DataCorp. mvEnterprise manual MvEnterprise Monitor Program, #prodpick -istacked.data

1.10 mvEnterprise Monitor Program

The following mvEnterprise monitor program options are available. These options are invoked by a dash, the lower case letter indicated, and in some cases, a parameter following the option.

-a	Restore ABS from a mvEnterprise release tape.
-d	Set default tape device. If not used, defaults to -d0. (See
	config.tape)
-dc	Sets the compressed virtual tape device as defined in
	config.tape (dc0, dc1, and so on).
-de	Set default Ethernet device. Allows the use of an Ethernet
	tape device to do a full file restore from another
	mvEnterprise virtual on the network. (See config.ethernet)
-dp	Sets the virtual tape device as defined in config.tape (dp0,
	dp1, and so on).
-e	Add file systems to mvEnterprise overflow without
	performing a save and restore. Used instead of the -xfor the
	first coldstart after adding file systems.
-f	Set file load flag. This causes a full file restore.
-g	Display system locks, group locks and stop.
-g{r}	Display host ID, system locks, group locks, record locks and
	stop.
-gu{r}	Display system locks, group locks, UNIX semaphore usage
	information, record locks stop.
-h	Inhibit the EXIT and SH/TOPIX commands for this line.
-i	Pass stacked data to mvEnterprise from the UNIX command
	line. The general format is:
	#prodpick -i'stacked.data'
	where stacked.data is the string to be passed to
	mvEnterprise. Note that the specified string must be
	surrounded by single quotation marks. The ‘stacked.data’
	is always be followed by a carriage return. Unlike the

mvEnterprise Release 4.1 on AIX Installation Guide Page 23