HP Raining DataCorp. mvEnterprise manual MvEnterprise Release 4.1 on AIX Installation Guide

As an alternative, flow control can be obtained by entering a numeric option to reflect the desired flow control. This option is formed by adding together the appropriate numbers from the table below to provide a more flexible control of flow.

0 No flow control

1X-on/off output control

2X-on/off input control

4 RTS/CTS output control

8 RTS/CTS input control

For example, the default flow control is the number 7 (7 = 1 + 2 + 4 from the table above) for bi-directional X-ON/OFF and output hardware flow control.

parity:	n 8-bit, no parity (default).
	s 8-bit, no parity, strip high bit.
	e 7-bit, even parity.
	o 7-bit, odd parity.

The default flow and parity control is -ryn, or x-on x-off flow control and 8-bit, no parity.

-s{n}	Set the baud rate for the terminal. Defaults to 9600.
-t	Set the UNIX terminal device address. This option has a
	parameter immediately following giving the UNIX path
	name of the terminal to use as the port. For example,
	-t/dev/pts01.If not supplied, the default is your local
	terminal, if running as a foreground task, and no terminal,
	(Phantom), if running as a background task.
-v	Alter the default number of virtual memory buffers for this
	line. This is followed by a number from 20 to 256. Since
	memory requirements for a 256 PICK printer are low,
	printer lines should be set to a value of 20 pages.

CAUTION: Altering the default number of virtual memory buffers for a line increases the true memory requirements of the system.

mvEnterprise Release 4.1 on AIX Installation Guide Page 25