Introduction | Media & Ink | Solutions | Front Panel | Printer | Other | Index | |||
Options | |||||||||
|
|
|
|
|
|
|
| ||
The Front Panel | Menu Structure | Navigating the Menu System | Message Descriptions | ||||||
|
|
| Front Panel Messages (Continued) |
|
|
| |||
|
|
|
|
|
|
|
| ||
|
| Message |
| Explanation and Action |
|
|
| ||
|
|
|
| ||||||
| Paper mispositioned | The paper is not properly positioned in the printer. Either it is out of | |||||||
|
|
| the load line margins or it has moved too much from its previous |
|
| ||||
|
|
| position. |
|
|
|
|
| |
Reload the paper following the normal procedure, to solve this problem. See Loading Roll Media and Loading Sheet Media.
Paper not found Press ENTER to retry Press CANCEL to abort
Paper not present.
Load paper to print calibration pattern
Paper too big to scan the pattern after printing it
During the loading of paper, the printer has detected that no paper has been loaded.
Either: Press the Enter key to restart the loading procedure;
Or: Press the Cancel key to cancel paper loading.
The paper axis calibration routine has been triggered with out having paper loaded.
Load paper; see Advance Calibration for details of the routine.
During the paper loading for the Calibration routine, the printer has detected that the it will not be able to load the later when it will be needed for scanning. The minimum size required for the print is 65 cm (25 inches) long and 50 cm (20 inches) wide.
Load a smaller sheet that satisfies this minimum requirement.
For more Messages, click on the Next Page button