Configuring TCP/IP Parameters
Using the control panel of your printer, you can manually configure these TCP/IP parameters:
•You can configure BOOTP, which automatically downloads configuration data over the network (this is the default setting), or
•You can enter these parameters individually:
•IP address (4 bytes)
•Subnet mask (4 bytes)
•Syslog server IP address (4 bytes)
•Default gateway (4 bytes)
•TCP connection timeout (in seconds)
NOTE | A valid IP address is required for proper operation |
|
| of the card on a TCP/IP network. |
|
|
|
|
|
|
|
NOTE | For DHCP (Dynamic Host Configuration Protocol) |
|
| operation, BOOTP must be enabled. |
|
| If an IP address is configured through DHCP and is |
|
| subsequently changed through the control panel, |
|
| the DHCP assigned address is released. |
|
| If a printer is configured through DHCP, and you |
|
| manually change the subnet mask or default |
|
| 3 | |
| gateway through the control panel, you should | |
| also change the IP address. | |
|
| |
|
| Printer Control Panel |
|
| |
|
|
|