4Get the banner paper ready for the printer:
■From the stack of banner paper, tear off the number of sheets you need to print the banner. (You must have at least five sheets in the stack.)
■Tear off the perforated strips, if there are any.
■Fan the stack so that the pages don’t stick together in the printer.
5Put the paper in the IN drawer so that the unattached edge is at the top of the stack. Insert the stack edge first into the IN drawer until it stops.
Unattached edge
6Slide the paper adjusters so that they fit snugly against the edges of the paper stack.
7Push the IN drawer back in.
8Print the banner.
You’ll notice that the printer and banner paper go through some
What If
THE BANNER
HAS A BIG GAP
OR A CREASE WHERE YOU DON’T EXPECT IT
The printer might be picking up more than one sheet of paper at
atime. Take the paper out, then fan the stack. Also be sure the top and bot- tom margins are set to zero in your banner program. Print the banner again.
THE BANNER PAPER JAMS IN THE PRINTER
•You might not have clicked Banner on the Setup tab in the HP print settings box.
•Try putting in more than five, but fewer than 20, sheets of paper.
•Make sure the banner switch is up.
•See the online trou- bleshooting for the appropriate set- tings for specific software programs.
•Make sure you remove all paper before loading the banner paper.
37