HP T1000 manual Selecting the UPS voltage configuration

Page 14

2.Connect the negative (black) lead to the negative battery terminal.

NOTE: A small amount of arcing may occur when connecting the batteries. This is normal and does not damage the unit or present any safety concern.

3.Replace the UPS front bezel.

Selecting the UPS voltage configuration

Using a small tool, position the DIP switches according to the desired voltage configuration as identified on the rear panel of the UPS and in the following table.

NOTE: The DIP switches must be set before powering up the unit. The unit does not change operating modes while powered up.

NOTE: An asterisk (*) indicates the default setting.

Output voltage

Input voltage range

DIP switch 2

DIP switch 1

Installation 14

Image 14

Contents HP UPS T1000/1500 User Guide Audience assumptions Contents Spares Index This section Component identificationUPS front panel UPS front panel controls and LED indicators UPS T1000 NA/JPN/TWN rear panel UPS T1500 NA/JPN/TWN rear panel UPS T1000 Intl rear panel UPS T1500 Intl rear panel Electrical requirements InstallationPrecautions Checking the battery recharge date Connecting the batteriesSelecting the UPS voltage configuration Connecting the host computer Connecting the serial communications portConnecting the Network Transient Protectors Connecting the USB communications portCharging the UPS batteries Connecting the UPS to utility powerConnecting devices to the UPS Powering up the UPS Audible alarm conditions Silencing an audible alarmPowering down the UPS UPS operationsUPS operations Power management HP Power Manager featuresBattery care and storage guidelines MaintenanceImportant battery safety information Updating the UPS firmware Replacing the batteriesUPS battery replacement procedure Disconnect the negative black lead Remove the battery module Cleaning battery spills Maintenance UPS operates on battery only TroubleshootingAudible alarm sounds UPS does not startPower LED flashes UPS frequently switches between utility and battery powerUPS does not provide the expected backup time Voltage Configuration LED is greenSite Wiring Fault LED is red Battery Charge LED is redBattery Warning LED is amber Output Load Level LED is red or flashing redT1500 physical specifications SpecificationsT1000 physical specifications UPS input specificationsT1000 power protection specifications T1000 output specificationsT1500 output specifications T1500 power protection specificationsBattery specifications Output tolerance specificationsOutput feature specifications Battery runtimePage Spares T1000 UPS spare parts listT1500 UPS spare parts list Ordering sparesHP contact information Technical supportBefore you contact HP $250,000 Computer Load Protection Guarantee Warranty informationLimited warranty Pre-Failure Battery WarrantyNotification from power management software Federal Communications Commission notice Regulatory compliance noticesRegulatory compliance identification numbers FCC rating labelClass a equipment Class B equipmentCanadian notice Avis Canadien ModificationsCables European Union regulatory noticeJapanese notice Bsmi notice Korean notice Battery replacement noticePower cord statement for Japan Grounding methods to prevent electrostatic discharge Electrostatic dischargePreventing electrostatic discharge Acronyms and abbreviations Index Index Index