HP T1000 Connecting the Network Transient Protectors, Connecting the USB communications port

Page 16

Connecting the USB communications port

CAUTION: Using a USB to serial converter cable will damage the UPS.

Connecting the Network Transient Protectors

CAUTION: To avoid damaging the equipment, use the Network Transient Protector with a standard telephone line only, not with a digital PBX.

To protect equipment against surges over a network data line:

1.Connect the network wall jack to the UPS Network Transient Protector IN jack.

2.Connect the equipment to the UPS Network Transient Protector OUT jack.

Installation 16

Image 16

Contents HP UPS T1000/1500 User Guide Audience assumptions Contents Spares Index UPS front panel Component identificationThis section UPS front panel controls and LED indicators UPS T1000 NA/JPN/TWN rear panel UPS T1500 NA/JPN/TWN rear panel UPS T1000 Intl rear panel UPS T1500 Intl rear panel Precautions InstallationElectrical requirements Checking the battery recharge date Connecting the batteriesSelecting the UPS voltage configuration Connecting the host computer Connecting the serial communications portConnecting the Network Transient Protectors Connecting the USB communications portConnecting devices to the UPS Connecting the UPS to utility powerCharging the UPS batteries Powering up the UPS Silencing an audible alarm Powering down the UPSAudible alarm conditions UPS operationsUPS operations Power management HP Power Manager featuresMaintenance Important battery safety informationBattery care and storage guidelines Updating the UPS firmware Replacing the batteriesUPS battery replacement procedure Disconnect the negative black lead Remove the battery module Cleaning battery spills Maintenance Troubleshooting Audible alarm soundsUPS operates on battery only UPS does not startUPS frequently switches between utility and battery power UPS does not provide the expected backup timePower LED flashes Voltage Configuration LED is greenBattery Charge LED is red Battery Warning LED is amberSite Wiring Fault LED is red Output Load Level LED is red or flashing redSpecifications T1000 physical specificationsT1500 physical specifications UPS input specificationsT1000 output specifications T1500 output specificationsT1000 power protection specifications T1500 power protection specificationsOutput tolerance specifications Output feature specificationsBattery specifications Battery runtimePage T1000 UPS spare parts list T1500 UPS spare parts listSpares Ordering sparesBefore you contact HP Technical supportHP contact information Warranty information Limited warranty$250,000 Computer Load Protection Guarantee Pre-Failure Battery WarrantyNotification from power management software Regulatory compliance notices Regulatory compliance identification numbersFederal Communications Commission notice FCC rating labelClass a equipment Class B equipmentModifications CablesCanadian notice Avis Canadien European Union regulatory noticeJapanese notice Bsmi notice Power cord statement for Japan Battery replacement noticeKorean notice Preventing electrostatic discharge Electrostatic dischargeGrounding methods to prevent electrostatic discharge Acronyms and abbreviations Index Index Index