HP T1000 manual UPS battery replacement procedure

Page 23

•Minimize the amount of time the UPS uses battery power by matching the UPS configuration with the utility voltage. See "Selecting the UPS voltage configuration (on page 14)."

•Keep the area around the UPS clean and dust-free. If the environment is very dusty, clean the outside of the UPS regularly with a vacuum cleaner.

•Maintain the ambient temperature at 25°C (77°F).

•If storing a UPS for an extended period, recharge the batteries ("Charging the UPS batteries" on page 17) every 6 months, and then update the battery recharge date label.

UPS battery replacement procedure

This component is hot-swappable and can be replaced without powering down the UPS.

1.(optional) To replace the component with the UPS powered down, refer to Powering down the UPS (on page 19).

2.Remove the UPS front bezel.

3.Remove the battery bracket.

Maintenance 23

Image 23

Contents HP UPS T1000/1500 User Guide Audience assumptions Contents Spares Index This section Component identificationUPS front panel UPS front panel controls and LED indicators UPS T1000 NA/JPN/TWN rear panel UPS T1500 NA/JPN/TWN rear panel UPS T1000 Intl rear panel UPS T1500 Intl rear panel Electrical requirements InstallationPrecautions Connecting the batteries Checking the battery recharge dateSelecting the UPS voltage configuration Connecting the serial communications port Connecting the host computerConnecting the USB communications port Connecting the Network Transient ProtectorsCharging the UPS batteries Connecting the UPS to utility powerConnecting devices to the UPS Powering up the UPS UPS operations Silencing an audible alarmPowering down the UPS Audible alarm conditionsUPS operations HP Power Manager features Power managementUpdating the UPS firmware Replacing the batteries MaintenanceImportant battery safety information Battery care and storage guidelinesUPS battery replacement procedure Disconnect the negative black lead Remove the battery module Cleaning battery spills Maintenance UPS does not start TroubleshootingAudible alarm sounds UPS operates on battery onlyVoltage Configuration LED is green UPS frequently switches between utility and battery powerUPS does not provide the expected backup time Power LED flashesOutput Load Level LED is red or flashing red Battery Charge LED is redBattery Warning LED is amber Site Wiring Fault LED is redUPS input specifications SpecificationsT1000 physical specifications T1500 physical specificationsT1500 power protection specifications T1000 output specificationsT1500 output specifications T1000 power protection specificationsBattery runtime Output tolerance specificationsOutput feature specifications Battery specificationsPage Ordering spares T1000 UPS spare parts listT1500 UPS spare parts list SparesHP contact information Technical supportBefore you contact HP Pre-Failure Battery Warranty Warranty informationLimited warranty $250,000 Computer Load Protection GuaranteeNotification from power management software FCC rating label Regulatory compliance noticesRegulatory compliance identification numbers Federal Communications Commission noticeClass B equipment Class a equipmentEuropean Union regulatory notice ModificationsCables Canadian notice Avis CanadienJapanese notice Bsmi notice Korean notice Battery replacement noticePower cord statement for Japan Grounding methods to prevent electrostatic discharge Electrostatic dischargePreventing electrostatic discharge Acronyms and abbreviations Index Index Index