HP T1000 manual Class a equipment, Class B equipment

Page 40

Class A equipment

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at personal expense.

Class B equipment

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit that is different from that to which the receiver is connected.

•Consult the dealer or an experienced radio or television technician for help.

Declaration of conformity for products marked with the FCC logo, United States only

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

For questions regarding this product, contact us by mail or telephone:

•Hewlett-Packard Company

P. O. Box 692000, Mail Stop 530113 Houston, Texas 77269-2000

•1-800-HP-INVENT (1-800-474-6836). (For continuous quality improvement, calls may be recorded or monitored.)

For questions regarding this FCC declaration, contact us by mail or telephone:

•Hewlett-Packard Company

P. O. Box 692000, Mail Stop 510101 Houston, Texas 77269-2000

•1-281-514-3333

To identify this product, refer to the part, series, or model number found on the product.

Regulatory compliance notices 40

Page 39 Page 41
Image 40
Page 39 Page 41
Contents HP UPS T1000/1500 User Guide Audience assumptions Contents Spares Index UPS front panel Component identificationThis section UPS front panel controls and LED indicators UPS T1000 NA/JPN/TWN rear panel UPS T1500 NA/JPN/TWN rear panel UPS T1000 Intl rear panel UPS T1500 Intl rear panel Precautions InstallationElectrical requirements Checking the battery recharge date Connecting the batteriesSelecting the UPS voltage configuration Connecting the host computer Connecting the serial communications portConnecting the Network Transient Protectors Connecting the USB communications portConnecting devices to the UPS Connecting the UPS to utility powerCharging the UPS batteries Powering up the UPS Silencing an audible alarm Powering down the UPSAudible alarm conditions UPS operationsUPS operations Power management HP Power Manager featuresMaintenance Important battery safety informationBattery care and storage guidelines Updating the UPS firmware Replacing the batteriesUPS battery replacement procedure Disconnect the negative black lead Remove the battery module Cleaning battery spills Maintenance Troubleshooting Audible alarm soundsUPS operates on battery only UPS does not startUPS frequently switches between utility and battery power UPS does not provide the expected backup timePower LED flashes Voltage Configuration LED is greenBattery Charge LED is red Battery Warning LED is amberSite Wiring Fault LED is red Output Load Level LED is red or flashing redSpecifications T1000 physical specificationsT1500 physical specifications UPS input specificationsT1000 output specifications T1500 output specificationsT1000 power protection specifications T1500 power protection specificationsOutput tolerance specifications Output feature specificationsBattery specifications Battery runtimePage T1000 UPS spare parts list T1500 UPS spare parts listSpares Ordering sparesBefore you contact HP Technical supportHP contact information Warranty information Limited warranty$250,000 Computer Load Protection Guarantee Pre-Failure Battery WarrantyNotification from power management software Regulatory compliance notices Regulatory compliance identification numbersFederal Communications Commission notice FCC rating labelClass a equipment Class B equipmentModifications CablesCanadian notice Avis Canadien European Union regulatory noticeJapanese notice Bsmi notice Power cord statement for Japan Battery replacement noticeKorean notice Preventing electrostatic discharge Electrostatic dischargeGrounding methods to prevent electrostatic discharge Acronyms and abbreviations Index Index Index
Top Page Image Contents