HP T1000 Output tolerance specifications, Output feature specifications, Battery specifications

Page 33

Configuration setting (VAC)	Available nominal output voltage (VAC)

230	230

240	240

Output tolerance specifications

Source of power	Regulation

Utility power (nominal	-10% to +6% of nominal output voltage rating
range)	(within the guidelines of the Computer Business
	Equipment Manufacturers Association)

Battery power	±5% of nominal output voltage rating

Output feature specifications

Feature	Specification

Online efficiency	94% nominal input voltage

Voltage wave shape	Sine wave; 5% THD with typical PFC load; 15-20% THD on battery

Surge suppression	High-energy 6500 A peak

Noise filtering	MOVs and line filter for normal and common mode use

Battery specifications

Feature	Specification

Type	12 V, 9 AH, sealed, maintenance-free, rechargeable, lead-acid battery.

Charging	Complete charge takes no more than 24 hours. After approximately 4 hours, the batteries
	reach 90% charge at default nominal utility voltage and no load.

Battery runtime

Load, percent	Load, watts	Estimated battery runtime at 100% battery charge

20	100	45 minutes

50	250	15 minutes

80	400	6 minutes

100	500	4 minutes

Environmental specifications

Feature	Specification

Operating temperature	0°C to 40°C (32°F to 104°F)

Nonoperating temperature	-15°C to 50°C (5°F to 122°F)

Relative humidity	0% to 95%; noncondensing

Specifications 33

Image 33

Contents HP UPS T1000/1500 User Guide Audience assumptions Contents Spares Index Component identification UPS front panelThis section UPS front panel controls and LED indicators UPS T1000 NA/JPN/TWN rear panel UPS T1500 NA/JPN/TWN rear panel UPS T1000 Intl rear panel UPS T1500 Intl rear panel Installation PrecautionsElectrical requirements Connecting the batteries Checking the battery recharge dateSelecting the UPS voltage configuration Connecting the serial communications port Connecting the host computerConnecting the USB communications port Connecting the Network Transient ProtectorsConnecting the UPS to utility power Connecting devices to the UPSCharging the UPS batteries Powering up the UPS Powering down the UPS Silencing an audible alarmAudible alarm conditions UPS operationsUPS operations HP Power Manager features Power managementImportant battery safety information MaintenanceBattery care and storage guidelines Updating the UPS firmware Replacing the batteriesUPS battery replacement procedure Disconnect the negative black lead Remove the battery module Cleaning battery spills Maintenance Audible alarm sounds TroubleshootingUPS operates on battery only UPS does not startUPS does not provide the expected backup time UPS frequently switches between utility and battery powerPower LED flashes Voltage Configuration LED is greenBattery Warning LED is amber Battery Charge LED is redSite Wiring Fault LED is red Output Load Level LED is red or flashing redT1000 physical specifications SpecificationsT1500 physical specifications UPS input specificationsT1500 output specifications T1000 output specificationsT1000 power protection specifications T1500 power protection specificationsOutput feature specifications Output tolerance specificationsBattery specifications Battery runtimePage T1500 UPS spare parts list T1000 UPS spare parts listSpares Ordering sparesTechnical support Before you contact HPHP contact information Limited warranty Warranty information$250,000 Computer Load Protection Guarantee Pre-Failure Battery WarrantyNotification from power management software Regulatory compliance identification numbers Regulatory compliance noticesFederal Communications Commission notice FCC rating labelClass B equipment Class a equipmentCables ModificationsCanadian notice Avis Canadien European Union regulatory noticeJapanese notice Bsmi notice Battery replacement notice Power cord statement for JapanKorean notice Electrostatic discharge Preventing electrostatic dischargeGrounding methods to prevent electrostatic discharge Acronyms and abbreviations Index Index Index